Installation Guide

INSTALLATION INSTRUCTIONS
FOR P8151-681
FOR 6 Light Pendant
WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E AK E R .
A V E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R
Page: 1/1
Fig. 2
PREPARING FOR INSTALLATION (Fig. 1)
1.
Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2.
Carefully unpack your new fixture and lay out all the parts in
a clear area. Take care not to misplace any small parts
necessary for installation.
SUGGESTED INSTALLATION (Fig. 1 and Fig. 2)
3. Remove the two mounting screws (E
) from the side of the
canopy (D) and remove the mounting plate (B).
4. Attach the mounting plate (B) to the junction box (not
included) with the two outlet box screws (C) provided.
5. One 6" rod and one 12" rod were assembled on the fixture
already, if not using additional rods, skip to step 9.
6. Loose the wire nuts for the fixture wires inside the canopy.
Put the short black and white wire aside. Loosen
the hex
nuts and l
ock washers to take the canopy (D) and front plate
off from the rods (F2).
7.
Thread the fixture wires up through the rods (F1) & (F2),
then tighten to the fixture body (G). Determine the desired
length of the item, adding the other rod (F1) or (F2) as
needed.
8. Thread the fixture wires from the front plate up through
the canopy (D), then secure with the lock washers and
hex nuts. Cut excess wire leaving 7” for installation.
CONNECTING THE WIRES (Fig. 2)
9. Connect the electrical wires as shown in Fig. 2, making s
ure
that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate (B
) using the green screw
provided. Tuc
k the wire connections neatly into the junction
box.
COMPLETING THE INSTALLATION (Fig. 1)
10. Attach the canopy (D
) to the mounting plate (B) and secure
it with the mounting screws (E).
11. Install the 6*40W Xenon bulb (I
) (included) in accordance
with the fixture’s specifications.
(DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!).
12.
Place the glass shade (J) over the socket and twist to
secure it to the socket cup (H).
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1 set#A-020
- Mounting plate
- Ground screw
- Mounting screws*2pcs
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)