Installation Guide

INSTALLATION INSTRUCTIONS
Item#P1403-613 (New. 03/12/2015)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Page: 1/2
Fig. 1
Fig. 3
LA-2463E
PREPARATION (Fig. 1)
1.
Shut off the power at the fuse box or circuit breaker. If
necessary, remove old fixture, including mounting
hardware.
2. Carefully remove the fixture from the carton
and
check that all parts are included as shown in the
illustration.
ASSEMBLING THE FIXTURE WITH BALL SWIVEL (Fig. 2)
3. Attach the mounting plate (A) to the junction
box
using mounting screws (B) (Size: #8-32N*L0.5”).
4. Determine the desired hanging height and thread rods
(F1, F2, and
F3) to the nipple (J) of the fixture body
(G).
Pass the wires carefully through each rod as you
assemble.
5. Place the canopy (C) over r
ods (F) and thread the
hanger ball (E) to rods (F). Pl
ease remove the nipple
if installing with one 6” rod only.
6. Install the fixture body into the mounting plate (A)
by
tilting at a slight angle so that
the hanger ball (E) slips
into the mounting plate (A) as shown.
Align the notch
in the hanger ball (E) to the tab on the mounting plate
(A) to prevent the fixture from turning.
CONNECTING THE WIRES (Fig. 3)
7.
At this point, connect the electrical wires as shown in
figure 3
, making sure that all wire connectors are
secured.
If your outlet has a ground wire (green or
bare copper), connect the ground wires from
the
hanger ball and mounting plate
to it. Otherwise,
connect the ground wire from the hanger ball
directly
to the mounting plate ground wire and secure with
the
wire connectors provided
. After wires are connected,
tuck them carefully into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig. 1)
8. Align the canopy (C) over the mounting p
late (A) and
secure with screws (D).
9. Install the light bulb(s) (not included)
in accordance
with the fixture’s specifications.
(DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (
NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note:
Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set
#
LTG BKT 10
-Mounting Plate
-Ground screw
-Mounting Screw*2
Rod#
W30
-
1
-
613
*1
(F1)
W30-1-613*2(F2)
W30-H-613*1(F3)
G
J
H
F3
F2
F1
C
D
A
B
E