Instructions / Assembly
Product Data Sheet
Peel & Stick RPS (Black)
GenTite™ RRS
250 West 96
th
Street
Indianapolis, IN 46260
800-443-4272 ● www.GenTite.com
Page 1 of 2 05/2011
DESCRIPTION
GenTite Peel & Stick RPS (Reinforced Perimeter Strip) is composed of reinforced EPDM laminated to a
cured Butyl based adhesive tape. GenTite Peel & Stick RPS is designed to be used as a non-penetrating
membrane attachment flashing. GenFlex Peel & Stick RPS should be used on GenFlex EPDM
membrane systems.
INSTALLATION
Refer to current GenTite Application Instructions for additional application instructions.
1. Attach the half of the RPS without the tape according to the applicable detail (unroll, align, and attach
at dots).
2. Thoroughly mix GenTite Primer. DO NOT THIN! A minimum of 2 minutes of vigorous hand mixing
with a wooden paint stirrer or its equivalent is required. All sources of ignition should be eliminated;
adequate ventilation should exist.
3. Clean all surfaces with a clean cotton rag removing excess contamination prior to application of the
primer.
4. With a scrub pad and handle, apply GenTite Primer to the membrane and metal flange using long
and continuous back and forth strokes with heavy to moderate pressure along the bonding area until
no streaks or puddling occurs.
5. Allow GenTite Primer to dry until slightly tacky to a dry finger touch.
6. Cut the Peel & Stick RPS to the desired length.
7. Peel off the release paper from the tape and apply the tape to the primed area.
8. Using a Teflon coated or hard rubber roller, hand-roll the membrane firmly to ensure uniform contact.
9. All caulking details will be completed per standard specifications with GenTite Edge Caulk. Apply a
continuous “high profile” bead of edge caulk at Field Seam Intersections, Cover Tape end laps, and
edge metal joints
.
APPLICATIONPRECAUTIONS
Substrate must be clean, dry smooth, free of sharp edges, tins, loose, or foreign materials, oil, grease,
and other materials which may damage the flashing.
All roughened surfaces which could damage the flashing shall be repaired as specified to offer a smooth
substrate.
Avoid globs and puddles when applying GenTite Primer.
PRODUCTDATA
SIZE QUANTITY PRODUCT #
6” (152.40 mm) x 50’ (15.24 m) Roll 2 Rolls per Carton W59GT30104