Manual

i
16
3.Securely fasten wires.
• Securely fasten wires to ceiling and
wall using insulated staples provided.
-Use insulated staples.
- Staples should be snug only. Insulated
• If rear cover is attached to power head, Staple
remove it,
• On power head:
- Route wall console wires through wire guide on
power head.
- Split and strip ends of wire (Fig. 3-2 on
previous page).
-Insert wire into terminal holes and lightly press in
the orange locking clips above each terminal
hole. (You can use a pencil or small screwdriver
to comfortably press in locking clips,) The white
wire into #t terminal hole and striped wire into
the #2 terminal hole.
- Confirm wire lock by lightly tugging on the wire,
The wire should remain in the terminal hole.
• Do NOT install rear cover yet.
4. Mounting,
• Fasten wall console to wall with 2 screws
(provided) (Fig. 3-4).
• Remove protective backing from "Entrapment"
warning label (Fig. 3-5). The "Entrapment" label
is located in the center of this manual.
- Stick label on wall near wall console.
_ii_.E|6_ii_:_3i_ii_i|_e_i._:i_es::_!i_i_ii_iii:i!i!ii!iii_ii:ii_ii_i_ii:_:iii_ii:_ii!_:;!ii!i_ii_:!;1_!!_ti!i_:_ii_::ii;ii!ii
_iii_i!_i_!i_!i!ii_i_i_!i_!iiiiiiiii_ii_ii_i!_ii_i_:ii!i!_i_!?i_iiiii:i_:::iiii!iii!i_i_!i_!_iiiii_ii:i_i:ii_i_!:!i:_i:_i!!i!!!_>_ii_ii_!Ki!:_i_iii:i!
PN# 3642036534, 02/26/2010 REV. I