Installation Guide

IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX.
Secure mounting bar (A) to outlet box with outlet box screws (not
supplied). Thread nut (B) on nipple (C) so that 3 threads are exposed
above nut (B). Thread nipple (C) into mounting bar (A) and secure
with nut (B). Thread screw collar (E) to nipple (C).
STEP 4:
U
sing 2 pairs of pliers, open one link of chain (S) and connect it to
the fixture loop (J) at the top of the fixture.
STEP 5:
S
lide the screw collar ring (F) and canopy (G), in that order, over
chain (H). Open one link on the other end of the chain (H) and attach
it to the screw collar (E) which has been mounted to the ceiling
nipple (C).
BE SURE TO CLOSE ALL CHAIN LINKS COMPLETELY.
STEP 6:
INSTALLATION HC-228
Lace wires up through chain (H) and pass wires through holes in
screw collar (E). We recommend lacing wire up through every other
link of chain (H).
STEP 7:
*PARALLEL WIRE (ROUND & SMOOTH) *PARALLEL WIRE (SQUARE & RIDGED)
BLACK WHITE
GROUP A:
CONNECT TO BLACK HOUSE WIRE
GROUP B:
CONNECT TO WHITE HOUSE WIRE
STEP 8:
A. Take note of the color of the wire(s) on your fixture. Identify which
group your fixture wire(s) falls into and connect the wires according
to the directions below:
*Note: When parallel wire is used, the tracer wir
e is square shaped or
ridged and less tracer wir
e is round in shape or smooth
(Seen best when viewed from wire end). To separate wires, grasp the
ends of each wir
e and pull apart.
B. T
ake your fixtur
e wir
e(s) fr
om group A and place evenly against
the black wir
e fr
om the outlet box.
DO NOT twist wir
es together
before using wire connectors.
C. Fit a wire connector (not supplied) over the wires and thread the
connector clockwise until you feel a firm r
esistance.
D. Gently try to r
emove the wir
es from the connector, If you can
remove the wires, carefully re-do steps B and C, as above and check
again for a firm connection.
E. Connect the fixture wire from group B to the white wire from the
outlet box in the same manner
.
GROUNDING INSTRUCTIONS: The green grounding screw (D) is to
be inserted into the hole with two raised dimples provided on the
m
ounting bar (A). Wrap the ground wire (M) from the fixture (if
supplied) and the ground wire from the outlet box (bare metal or
green insulated wire) around the green grounding screw (D) on the
mounting bar (A) if uninsulated wire is on the mounting bar (A),
c
onnect the ground wire (M) from the fixture (if supplied) and the
outlet box to it using a small wire connector (not supplied).
N
EVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
STEP 4:
After wires are connected, tuck them carefully inside outlet box.
Raise canopy (H) against ceiling and thread the screw collar ring (G)
to the screw collar (E).
Make sure no bare wires can be seen outside wire connectors.
Install lamps (not supplied).
FINAL ASSEMBLY
STEP 5:
STEP 6: