Installation Guide
STEP 1:
FIGURE 1
*NOT SUPPLIED
• Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
• Use of other manufacturers components will void warranty, listing
a
nd create a potential safety hazard.
• You don’t need special tools to install this fixture.
•
Be sure to follow the steps in the order given.
•
Read instructions carefully.
• If you are unclear as to how to proceed, contact a qualified
electrician.
• Save these instructions.
IMPORTANT SAFETY INSTRUCTIONS
*OUTLET BOX
*OUTLET BOX
SCREWS
*WIRE
CONNECTORS
SCREW
COLLAR (E)
CANOPY (G)
MOUNTING
BAR (A)
*GROUND WIRE
CHAIN (H)
NUT (B)
SCREW COLLAR
RING (F)
FIXTURE LOOP (I)
GREEN
GROUNDING
SCREW (D)
NIPPLE (C)
CANDLE
COVER (P)
N
OTE: This glass is handcrafted, the slight imperfections in the
glass add to the authenticity of the fixture.
Attach break assembly to shade by threading nipple (J) onto coupling (L)
(if applicable).
Secur
e in place by threading loop (I) onto nipple (J).
Carefully remove the fixture from the carton and check that all parts are
included, as shown in figure 1 and 2. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
Pass fixture wires thru break assembly (K) (if applicable).
1. Remove the 3 retaining screws, and remove the cage.
2. Remove the cardboard packaging.
3. Replace cage and screws.
IF APPLICABLE: TO REMOVE THE PACKAGING
ASSEMBLY
STEP 2:
STEP 3:
COUPLING (L)
NIPPLE (J)
BREAK
ASSEMBLY (K)
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
HC-228
1
12408
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
BEFORE YOU BEGIN
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
CLEANING
ORDERING PARTS