Manualshelf

Installation Guide

ManualsBrandsGeneration Lighting Designer Collections ManualsChandeliersED Ellen DeGeneres Crafted by Generation Lighting Atlas 12.5 in. W 1-Light Aged Iron Cage with Seeded Glass Orb Pendant
12
1
Installation Instructions for
Atlas Pendant
1.0
EP1101
Pendant
EP1101
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
1
2
1A
3
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
Feed the fixture wires through the swivel stem, then screw the swivel stem to the top of the socket assembly.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Carefully insert the socket into the glass at an angle until the stopper is inside the glass, then lower the cover onto the glass, and
secure in place by screwing the cap onto the threads above the stopper.
Feed the fixture wires through the washer and frame, then carefully lower the frame over the shade.
Screw the half ball to the stem which will be on top.
Determine the wanted height or look of the fixture with the provided stems, then assemble them by screwing them together.
Feed the fixture wires through the stem assembly, then screw the stem assembly to the top of the swivel stem.
Feed the fixture wires through the collar nut, canopy, and half ball assembly, then screw it onto the stem assembly.
Align and secure the mounting plate to the junction box, then slide the half ball assembly onto the mounting plate.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate and secure it in place by screwing the
collar nut tightly onto the mounting plate.
4
5
6
7
8
9
10
11
12
STEM ASSEMBLY
CANOPY
HALF BALL ASSEMBLY
MOUNTING PLATE
JUNCTION BOX
STEM
HALF BALL
COLLAR NUT
7
11
SOCKET ASSEMBLY
FRAME
LAMP
SWIVEL
STEM
SOCKET
ASSEMBLY
LAMP
COVER
CAP
STOPPER
SHADE
SWIVEL STEM
WASHER
THREADS
12
13
4
1
2
3
5
8

Summary of content (2 pages)