Instruction Manual

Page 6
owners manual
gm-x
SELECTING THE PARTS (CH) IN GM2 MODE
SELECTING THE PARTS (CH) IN GM2 MODE
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): SOUND
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): SOUND
The LED #2 lighting on indicates the selection of the sound bank #2
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): VOLUME
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): VOLUME
Volume - Volume +
Part disabled
It is possible to select 16 different parts, corresponding
to the 16 standard MIDI channel.
Once all the 16 MIDI channel have been selected, the
display will show the message "ALL". This condition allows
you to modify some parameters values at the same time,
speeding up the editing operation. See on Page N.8, for
further details.
Press repeatedly the DATA button, the display will
show the PART (CH) number you wish to edit
The current default value of the selected parameter, is shown in the
display. In the part # the sound is: GRAND PIANO, the DOT closest
to the fi rst digit indicates the sound BANK (#01). Please refer to the
included sound list at the end of the manual.
Once you have selected the PART you wish to modify
(#01 in this example), the EDIT menu parameter are
selected by pressing the EDIT button. Each time you
press the button a different parameter is selected.
Pressing the DATA button you select the next sound
in the sound database.
In order to ease and speed up the sound selection, the sounds
are mapped according to GM mapping. For each sound it’s
possible immediately to select its VARIATION, (an alterna-
tive sound belonging to the same timbrel family, located in
a subsequent bank.)
Each time you press the DATA button a next sound
is selected.
The second or third dot lighting on in the display,
indicates the selection of a sound variation located
in a subsequent sound bank.
The GM-X has 4 sound banks in total. From bank 0 (no dot light up
in the display), to bank 3 (three dot ligh up in the display).
To select the VOLUME parameters of the selected PART
(CH) sound, press the EDIT button once more time. The
current default value of the parameter is indicated in
the display. Volume = 100 in this example.
You can increase or decrease the volume level, by
pressing the DATA buttons. The display show
you in realtime the value changing.
Once you have reached the VOLUME = 000, (minimum sound
level), by pressing once more again the DATA button you'll set
the selected part OFF, then the part is disabled.
NOTE