Use And Care Manual

GAS PRESSURE KITS
Please read this manual carefully and thoroughly before using this product.
GPK005/GPK015/GPK035
INSTRUCTION MANUAL
GPK005/GPK015/GPK035
INSTRUCTION MANUAL
GPK005/GPK015/GPK035
INSTRUCTION MANUAL
Get accurate pressure readings when checking
and setting manifold pressure of furnaces and
appliances that use natural gas or LP gas
OPERATING INSTRUCTIONS:
1. Turn off gas. Remove gas inlet supply/
manifold fitting.
2. Use hose clamp to attach non-flared end
of tubing to gauge
3. Install supplied brass fitting into manifold
4. Push flared end of tubing onto barbed end
of brass fitting. Turn on gas and begin
pressure test.
5. Remove hose
6. Reassemble manifold
NOTE
: Before taking final pressure reading,
tap gauge lightly to relieve any built-up friction
CAUTION!
Handle carefully.
The special diaphragm gauge is very sensitive.
Do not drop!
Do not over pressurize!
APPLICATIONS:
• Home
• Office
• Factory
•
Appliances
• Piping
• Recreational Vehicles
FEATURES:
• Measure natural gas (methane) or LP gas
pressure across appliance manifolds
• Test gas stoves, furnaces, dryers and other
gas appliances. Can also be used for other
corrosive gases.
• Large 2.5 in. diameter diaphragm gauge
is calibrated in inches of water column,
also shows ounces per square inch
(GPK015/GPK035 only)
• Magnified lens
• Easier to use than a manometer
SPECIFICATIONS:
• GPK005 Range: 0 to 5 psi
• GPK015 Range: 0 to 15 inches of water
column (in. H
2
O)/0 to 9 ounces per
square inch (oz./in
2
)
• GPK035 Range: 0 to 35 inches of water
column (in. H
2
O)/0 to 20 ounces per
square inch (oz./in
2
)
• Measurement Accuracy (all models):
±1.5% of full-scale range
• Dimensions: 2.5 in. gauge, 39 in. rubber tubing
• Weight: 10.2 oz. (285g)
INCLUDES:
2.5 in. diameter diaphragm gauge, 39 in.
of rubber tubing, 3/8 in. NPT brass fitting
for quick connection to appliance manifold,
hose clamp, molded hard case
GENERAL TOOLS & INSTRUMENTS
75 Seaview Drive Secaucus, NJ 07094-1806
PHONE [phone] FAX [phone]
TOLL FREE [phone]
e-mail: [e-mail]
www.generaltools.com
GPK005/GPK015/GPK035 Instruction Manual
Specifications subject to change without notice
©2015 GENERAL TOOLS & INSTRUMENTS
NOTICE - WE ARE NOT RESPONSIBLE FOR TYPOGRAPHICAL ERRORS.
INSTRUC#GPK005/GPK015/GPK035 05/11/15
• GPK005 is calibrated in psi and meets
requirements of Section 406.4 of the
NEW YORK CITY FUEL GAS CODE (2008)
General Tools & Instruments
GeneralToolsNYC