Install Manual
PMN: PWRview Communications Module
QUESTIONS OR FEEDBACK?
WWW.GENERAC.COM/SERVICESUPPORT/CONTACTUS
FCC PART 15
This device complies with FCC Rules Part 15 operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference, including interference that
may cause undesired operation of the device.
Changes or modifications to this device, not expressly approved by
Generac Power Systems, Inc. could void the user’s authority to operate
the equipment.
Contains FCCID: W72-N1LD
Contains IC: 8253A-N1LD
INDUSTRY CANADA NOTIFICATIONS
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage;
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement
FCC RF EXPOSURE REQUIREMENTS
This product complies with the FCC RF exposure limit set forth for
an uncontrolled environment and is safe for intended operation as
described in this manual. This device is only authorized for use in a
mobile application, at least 20cm of separation distance between the
radiating antenna and the user's body must be maintained at all times.
Further RF exposure reduction can be achieved if the product can
be kept as far as possible from the user’s body or set the device to a
lower output power if such a function is available. Separate approval
is required for all other operating configurations, including portable
configurations with respect to 47 CFR Part 2.1093 and dierent
antenna configurations
WARNING
!
Installing PWRview requires working
with voltages that may cause serious bodily injury or even death, and
thus should only be done by a qualified professional. Installations
should be performed in accordance with the applicable electrical code
for the region in which PWRview is being installed. Whenever possible,
power should be disconnected upstream from the installation location
before attempting installation of PWRview. If power cannot be
disconnected, high voltages may still be present, and warning must be
taken to avoid injury. If PWRview is not used as instructed, its
protection mechanisms may be impaired.
RULES:
1. Installations should be performed by a qualified professional and in
accordance with the applicable electrical code for the region in which
PWRView is being installed.
2. Do not use PWRview with voltages that exceed 240V.
3. Only install PWRview in approved breaker panels or enclosures.
4. PWRview must not be exposed to moisture, direct sunlight,
extremely low or high temperatures, and conductive pollution. Consult
the User Manual for PWRview’s acceptable operating environment.
5. PWRview must be installed in a location that limits access to only
qualified personnel.
ATTENTION
OBSERVE PRECAUTIONS FOR HANDLING
ELECTROSTATIC SENSITIVE DEVICES
WARRANTY INFORMATION CAN BE FOUND AT:
WWW.GENERAC.COM/SERVICESUPPORT/PWRVIEW
Part No. A0000355160 REV A