User's Manual

English 3
8330A
RESET TOFACTORY
SETTINGS: PUSH
BUTTONFOR 10SEC
COMPOSANTÀL'INTÉRIEURREMPLAÇABLEPAR
OUVRIR.NE PASEXPOSERÀL'EAUOU L'HUMIDITÉ.AUCUN
L'UTILISATEUR.ADRESSER TOUTERÉPARATIONÀUN
PERSONNELQUALIFIÉ. CETAPPAREILDOIT ÊTRE
RACCORDÉÀLATERRE.
NOTSUBJECTTOWATER ORMOISTURE. NOUSER SERVICEABLE
PARTSINSIDE.REFER SERVICINGTO QUALIFIEDPERSONNEL.
USEEARTHEDMAINSCONNECTION ONLY.
ELECTRICSHOCK HAZARD.DO NOTOPEN. DO
WARNING:
AVERTISSEMENT:
LAITEONLIITETTÄVÄSUOJAMAADOITUSKOSKETTIMILLA VARUS-
TETTUUNPISTORASIAAN. APPARATETMÅTILKOPLES JORDET
STIKKONTAKT.APPARATENSKALL ANSLUTAS TILLJORDATUTTAG.
MADE INFINLAND
MAGNETICALLY SHIELDED
www.genelec.com
SERIALNUMBER
This devicecomplieswith FCC Part15andCanadian
ICES-003 radio frequencyClassBemissionrequirements.
Refer to operatingmanualforfullinformation.
MAINSINPUT
50 /60Hz60W
100 - 240 V~
GLMNETWORK
SMARTACTIVE MONITOR
292-8030W
RISQUEDE CHOC ÉLECTRIQUE. NE PAS
DIGITAL
IN
292-8330T-6
ANALOG
IN
DIGITAL
OUT
+
- GND
2
3
112
3
GND
-
+
INOUT
GLM
NETWORK
CONNECTORS
MAINS
INPUT
POWER
SWITCH
SIGNAL CONNECT
ORS
- DIGITAL IN
- DIGITAL OUT
- ANALOG IN
Figure 3: GLM Network Adapter
cabling. Audio cabling is not
shown.
LISTENING
POSITION
MICROPHONE
GLM
NETWORK
GLM
NETWORK
GLM
NETWORK
USB
Analog Audio Input
The analog audio input on both models accepts a
balanced male XLR connector.
Digital Audio Input
The 8330A digital audio input (DIGITAL IN) accepts
a male XLR connector carrying an AES/EBU
formatted digital audio signal. The digital audio can
be routed to the next monitor or subwoofer using
an XLR output (DIGITAL OUT). The AES/EBU digital
audio subframe A or B is selected using the GLM
software.
Figure 2: Control and connec-
tor layout on the rear panel
of an 8330A. The 8320A has
an analog input only, and the
GLM network connectors point
downwards and are located
next to the audio input.