Instructions / Assembly

Congratulations! You are the proud owner of a Gemmy Life-Size Figure. Please read

over the directions carefully before using your new ﬁgure.

Please keep these instructions for future reference because they contain important information.

PACKAGE CONTENTS

Base 1 piece

Torso 1 piece

Head 1 piece

Poles 5 pieces

Crossbar Support 1 piece

Clothes 1 piece

Support poles 4 pieces

Adaptor 1 piece

Input:

100-240 V ~ 50/60 Hz

Output: 9V 1500mA

PREPARATION

Estimated assembly time: 15-20 minutes.

Before beginning assembly, remove all parts from carton. Compare parts list and diagram above. If any part

is missing or damaged, do not attempt to assemble or use the product.

ASSEMBLY INSTRUCTIONS

1. Set base and pieces on a clear, ﬂat surface and assemble leg supports as shown.

If placed on uneven surface, please insert the four pieces support poles into the

corners of base.

2. The character Suit MUST be placed over the leg supports BEFORE the rest of the

Crossbar Support is assembled.

3. Assemble the Crossbar Support as shown in illustration 1. Place remaining support

pole into the hole located on top of crossbar support.

4. Attach shoulders onto frame as shown. Run the cord down from the shoulders,

through the plastic support disc, and connect the cord from torso to the cord from

base.

5. Finish putting the character clothes on frame by pulling the arms gently through

sleeves. Secure the suit in the back by hook and loop fasteners. Adjust as desired.

6. Attach head as shown, making sure it clicks securely into place.

7. Plug in Adapter to the port located on base. This power unit is intended to be

correctly oriented in a vertical or ﬂoor mount position.

8. Unplug adapter when not in use.

55392 E

ANIMATED FIGURE

INSTRUCTIONS

illustration 1

PAGE 1
55392 E ANIMATED FIGURE INSTRUCTIONS Congratulations! You are the proud owner of a Gemmy Life-Size Figure. Please read over the directions carefully before using your new figure. Please keep these instructions for future reference because they contain important information.
PAGE 2
OPERATION INSTRUCTIONS “OFF/SENSOR” toggle switch is located on back of shoulders. OFF: Slide switch to “OFF” position to deactivate the item. SENSOR: Slide switch to “SENSOR” position, then make a noise or wave your hand in front of figure to activate. STORAGE Do not discard box as it should be used for storage. It is helpful to loosen the belt before disassembly. Return all parts to the original packaging. Store in a cool, dry location.
PAGE 3
WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.