POP-IT™ Tool Model P95-525 Warning Improper use of POP-IT™ Tools may result in injury or death. Do Not Exceed Rated Load of 10,000 lbs. Always Chock Your Work. Follow operating procedures. GEARENCH™ P.O. Box 192 4450 South Highway 6 Clifton, Texas 76634 Phone: (254) 675-8651 Fax: (254) 675-6100 © 2008 by GEARENCH.
Table of Contents POP-IT™ Tool Description .............................................................................................. 2 Warranty ........................................................................................................................... 2 Safe Practices and Procedures ......................................................................................... 4 Responsibility ...................................................................................................
POP-IT™ Tool Description The POP-IT™ Tool takes the place of the hammer, pry-bars and wedge when working with flanges. It can also be used as an equipment lifting tool. The Model P95-525 reduces the risk of injury, is lightweight and compact and requires minimal maintenance. The tool holds its setting without drifting, has precision adjustment and can spread 5 tons to 5 ¼ inches. The Model P95-525 is unique for tight spots since it has ratcheting action and a .070 inch entrance.
This GEARENCH LIMITED WARRANTY is the sole and exclusive warranty, express or implied for GEARENCH products. No employee, agent, dealer or other person is authorized to alter, modify, expand or reduce the terms of this warranty or to make any other warranty on behalf of GEARENCH.
Safe Practices and Procedures Responsibility "It is the responsibility of the employer to train the employee in the proper selection and use of tools, and to ensure that they are selected and used in that manner. A part of the job instruction program should therefore be detailed training in the proper use of POPIT™ Tools. "Employers are responsible for the safe condition of tools and equipment used by employees, including tools and equipment which may be furnished by employees." (Source: OSHA 1910.
Every six months: Remove screw assembly. Remove any debris from the screw and apply a thin coat of anti-seize compound. Operating Procedure – Flange Work Note: In some cases it will be necessary to use two tools to keep from pinching the blind or gasket on the opposite side of the flange, or the flange may be so large and rigid that it requires two tools. When using two tools, it is very important to operate the tools in sync with one another while opening and closing.
comes free. After removing the chock, flip the direction switch to the right. Turn the ratchet handle counter clockwise until the flange is back to parallel. Step 6 Remove the POP-IT Tool from the flange. If necessary, remove the tool by tapping lightly on the side of the tool with a hammer. Operating Procedure – Lifting Work Step 1 Before every use, clean the serrations on the toes with a wire brush.
comes free. After removing the chock, flip the direction switch to the right. Turn the ratchet handle counter clockwise until the equipment is lowered to its desired position. Remove the tool.
Item No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Qty Part No.
