Installation guide

Installation Instructions

STEP4 INSTALL ANTI-TIP BRACKET

(cont.}

Install Wall Toggles:

The wall toggles and bolts con be ordered as Service

Kit #WR49X10193. Wall toggles ore installed in the

drywall and metal studs for stability. Install the wall

toggles as follows:

• Drill 1/2" holes at the wall markings mode in the holes

at the ends of the wall bracket.

• Hold the metal channel flat against the plastic strops

and slide the channel through the hole.

Plastic Straps

InstallScrewsand Bolts:

• Have someone holdthe wallbracket centered

in place with each of the holes aligned with

the correct opening in the bracket and level

with the horizontal line.

• Insert the lag screws through the bracket

and into the stud. Tighten with a wrench.

Wood Stud

Metal Channel

• Gently pull back at the ends of the plastic strops

to make the channel rest flush behind the wall.

• Hold the ends of the strops in one hand and slide

the plastic cop along the strops until the flange

of the cop is flush with the wall.

Cap _I

• Place your thumb between the plastic strops and

bend up and down to snap the strops off at the wall.

Anti-lip Wall Bracket

• Insert the bolts into the toggle by hand until snug.

Tighten with a wrench.

Drywallor

Steel Stud

\\\\

Bolt

Anti-Tip Wall Bracket

Wall Toggle