Installation guide

Cabinetry
Cutout for 30"(76.2cm) Single or Double
Built-In Ovens only- Over a
Warming Drawer
For JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960,
ZET938, ZET958 models only.
Single 30" (76.2 cm)
Oven Over a Warming
Drawer
Double 30" (76.2 cm)
Oven Over a Warming
Drawer
Per Warming
Drawer
Requirement
Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
NOTE: install the
oven only with
specific models
Iisted on the labeI
located on top of
the oven.
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
Anti-Tip Block
Against Rear
Wall Per
Warming
Drawer
Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
1" (2,5 cm) Min. Above Toekick
° When installing a Warming Drawer below
a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for
specific installation requirements.
12