Installation guide

Cabinetry Modification Suggestions
30" Buill-I_ ( o_vedio_ Ovens
Cut rail
for filler
panel
Cut the rail out of linished material:
• Tile width should match cabinet opening width.
• Tile height of tile top rail should be enough to
securely attach the rail to dae appearance panel,
plus 1/4" oven trim overlap.
• Tile height of tile bottom rail should be enough to
securely attach the rail to tile appearance panel,
plus 7/8" oven trim overlap.
• Tile height of both the top and bottom rails should
be a_!justed depending upon the height of the gap
to be filled or to enhance appearance.
TopRail
Lengthto Match
CabinetCutoutOpening
Bottom Rail
Lengthto Match
Cabinet Cutout Opening
Cut appearance
panel
Else drawer fl-onts for appearance panels or cut
finished material and finish raw edges.
• The appearance panel width should match drawer
fronts or doors.
• Make the appearance panel appropriate height to
fill the gap above or below the oven, allowing for
reveals and overlaps to match existing drawers or
dooYs,
Width to Match
drawers ordoors
Determine
location
of cleats
_ FramedCabinet _'
Appearance Panel
MarkCorners
with Pencil
Inside Front
of Cabinet
Frameless Cabinet
with Pencil
Inside Front
of Cabinet
• To find the exact position of the cleats, place the
appearance panel onto tile cabinet in desired
position and align to match tile other drawers and
dooI's.
• Use a pencil to mark tile back side of tile panel
where it meets the cabinet corners.
f 4