Installation guide

Installation Instructions
[STEP 208V ELECTRICAL SUPPLY
WARNING
These ovens are pre-wired for connection to 240volt,
60 HZ, supply. If connecting to a 208 volt supply,
modifications must be made.
AVERTISSEMENT
Ces fours sont c_bl_s pour branchement sur une
alimentation en 240 V, 60 Hz. It faut faire des modifica-
tions en cas de branchement sur une alimentation en
208 V.
SKIP THIS STEP IF YOU ARE CONNECTING
TO 240 VOLT POWER SUPPLY.
If connecting to a 208 volt, 60 HZ supply, a jumper
must be used across two terminals.
For double ovens, there are two jumpers, one for the
upper oven, one for the lower oven.
For single ovens there is one jumper.
FOR SINGLE OVENS, UPPER OVEN ON DOUBLE OVENS
_L_m_ er _Loosen Screws
o
Jumper Tighten Screws
To connect to 208V circuit:
Remove the access panel(s) located on the back of
the ovens.
Loosen the first and second screws in the terminal
block as shown.
Remove the jumper and place between the first and
second screws, tighten the screws to hold the
jumper.
Replace the access panel(s).
FOR LOWER OVEN ON DOUBLE OVENS
Loosen Screws_
o
Jumper
Loosen the first and second screws in the terminal
block as shown.
Jumper Tighten Screws
Remove the jumper and place between the first and
second screws, tighten the screws to hold the
jumper.
10