Installation guide

Installation Instructions
To install a single metal bottom trim assembly (on some models), use sections C3 and C4.
To install a metal bottom trim with a plastic bottom trim (on some models), use sections C3-C5.
Preparing for the Bottom
Trim Installation
a.
b.
c.
d.
With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
Using the trim
as a template,
mark the center
of each slot
(two total) where
the mounting holes
will be drilled.
Remove the trim.
Drill pilot holes into the
center of each template mark.
With Lower Trim _'_i,,,I,i},,
"n Poston Mark ,%_1111111
(2)MountingHole_,_iltl
Locations /_N
Lower Trim
Before
Pre-drilling
Mounting
Holes
[C4-] Installing the Metal
Bottom Trim
a. Place the bottom metal trim centered over
the pre-drilled mounting holes. Tape the
edges of the trim down to maintain the
alignment.
Side
/Trim
Trim Screws
Side
Trim
Metal Lower Trim
b. Using two trim screws provided, secure
the bottom trim to the bottom edge of the
cabinet.
Installing the Plastic Bottom
Trim (on some models)
a. Make sure flat side is up on the plastic
bottom trim.
b. Find the key slot on the back of the trim.
Key Hole Slot and Wide Flange at Top
c. Match the key slot with the rivet on the
bottom of the side trim, and lower the trim
onto the rivet.
Lower Trim Mounting Rivet
on End of Metal Lower Trim
d. Push the trim down, at both ends, until it
snaps into place.
Push Trim Down at Both Ends
Until it Snaps Into Place
CAUTION: Be sure you