Design Guide with Installation Instructions Wine Chiller, Wine Reserve and Beverage Center monogram.
Safety Information BEFORE YOU BEGIN: WARNINGS: Read these instructions • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the unit before cleaning or making repairs. • Repairs should be made by o qualified service technician. completely and carefully. IM PORTANT - Save these instructions for local inspector's use. IM PORTANT - Observe all governing codes and ordinances.
Design Guide THE INSTALLATION SPACE 34-1/2"-35" 24-1/8" Framed Models Min. 23-3/4"Stainless SteelModels PRODUCT CLEARANCES Thestainlesssteelwine chiller,wine reserveand beverage center isfactorg set for a 110°door swing. Modelsthat accept custom panelshavea 95° door swing. When installed in a corner: • Allow 4" min. clearance on the hinge sidefor the 90° door swing and to allow racksto slideout. • Allow 10" minimum clearanceon the hinge sidefor a full 110° door swing.
Installation Instructions TOOLS REQUIRED STAINING WOOD DRAWER FRONTS • #2 Phillips screwdriver • Adjustable wrench The drawer fronts are unfinished cherrg wood. During use, oil from hands may accumulate and stain the wood. • The drawer fronts may be stained and sealed to match adjacent cabinetrg. The tinted glass will make the stained wood appear darkeE A true color match can be seen onlg when the door is opened. • Applg the stain and sealer according to the manufacturer's instructions.
Installation Instructions ISTEP 2 IREVERSE DOOR SWING SKIPTHIS STEPIF DOOR SWING SUITSTHE INSTALLATION Install 3 Hinge i Screws i Parts Included: • Top left case hinge • Bottom left case hinge _ Remove Top Hinge • Left and right side decorative hinge cover • Decorative hinge screw hole cover • Torx ® driver bit Hinge Pin and Bracket Tools Required: • Phillips screwdriver • Electric drill Remove the door: • Flatten the shipping carton to use as a pad. • Remove the 2 screws and the toekick.
Installation Instructions ISTEP 31 LEVEL CUSTOM FRAME PANEL MODELS • Use an adjustable wrench to turn the leveling legs and raise or lower the product. • Adjust carefullg; the product should be level and plumb with cabinetry, and should align with adjacent toekick height. Model ZDWI240WIIand ZDBI240WlI Thesemodels require a custom panel frame surrounding the glass.Thereare two options:the panel mug be 29-3/4" or 30" high.
ZTBSS1 Monogram BEFOREYOU BEGIN: Read these instructions completely and carefully. IM PORTANT - Save these instructions for Iocul inspector's use. IM PORTANT - Observe oil governing codes Tubular Handle Kit TOOLS AND MATERIALS REQUIRED • • • • • • Gloves to protect against sharp edges #2 Phillips screwdriver Drill and 1/4" bit and 1/2" spade bit Safety glosses Center punch Pencil and ordinances. Note to Installer - Be sure to leave these instructions with the Consumer.
TEMPLATE FOR NAMEPLATE LOCATION _,j__ C_ut on DottedLine r 4: Upper Left Cornerof Glassif Hinge is on Left _Top of GlassDoor Topof Badge_y Upper Right Cornerof Glassif Hiflge is on Right Monogram. :4 DoorFrameSide DoorFrameSide DOORNAMEPLATELOCATION To position nameplate: • Cut template along dotted line. • Hold or tape template behind glass door so that it is visible from the front side. • Remove backing from nameplate.
