Use and Care Manual

14 49-60744 Rev. 6
PLUMBING - DRAIN PUMP
Drain Installation
A drain pump is available for this ice machine. The
GUDLQSXPSNLWQXPEHULV83.DQGLVDYDLODEOHDW
GEApplianceparts.com or by calling GE
Appliances at ,Q&DQDGDYLVLW
GEAppliances.caRUFDOO
PLUMBING - GRAVITY DRAIN
Drain Installation
NOTICE
Restrictions in the drain
system to the machine will cause water to back
up into the ice storage bin and melt the ice.
Gravity drain tubing must be vented, have no
kinks, and slope to the building drain. Air gaps
are typically required by local codes.
1. Place the ice machine in front of the installation
opening. Adjust leveling legs to the approximate
KHLJKW7KHUHDUH/HJ&DSVLQWKHKDUGZDUH
packet that can snap onto the leveling legs if
they are going to show when the unit is level.
2. Insert drain tube through the routing hole in the
back panel.
3. Remove the upper back panel if needed for
access to drain connection.
NOTE: If the drain opening has been located in the
floor under the base pan according to the pre install
specifications, follow steps 4 through 7 to drain the
unit through the base. If not, proceed to step 7.
Drain tubing
inside cabinet
Installation Instructions
INSTALLATION INSTRUCTIONS
HANDLE REVERSING INSTRUCTIONS
1. Remove the allen wrench from the panel
installation screw kit envelope
/RRVHQWKHVHWVFUHZXVLQJWKHDOOHQZUHQFK
Remove the handle and flip it around so the logo is
facing the other way.
3. Place the handle caps over the fasteners of the
door. Take care to support the handle so it doesn’t
fall and scratch the appliance finish. Make sure
both handle caps are resting on the face of the
door.
/RFNRQHHQGRIWKHKDQGOHLQWRSRVLWLRQE\
tightening the set screw in the handle cap with the
allen wrench provided. DO NOT over-tighten.
.HHSVXSSRUWLQJWKHKDQGOHDV\RXORFNWKHRWKHU
end of the handle into position by tightening the set
screw in the handle cap. DO NOT over-tighten.
LOOSEN
set screw
set screw
fastener
handle cap
set screw
set screw