Installation guide

Installation instructions
Cutout for 30"(76.2c )Sing Built-in
Ovensonly
For JTP30, JTP70, PT916, PT920, ZET938 models only.
Allow 11/16"
(1.75 cm) for
overlap of oven
over side edges
of cutout
21 "
(53.3 cm)I'Y_'_ -
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
corners, drawers,
walls, etc. when
door is open
Cutout
Width
28 1/2" (72.4 cm)
5/8"(72.7ore)
Max.
Opening
Between
inside Walls
Must Be
At Least
28 1/2"
(72.4 cm)
Wide
_AIl_w 1" (2.5 cm)
minimum for
overlap of oven
top and 1V4"
(3.2 cm) overlap
of oven bottom
of cutout
_--_ Cabinet
Width
30" (76,2 cm)
9 1/2" (24.1 cm)
Junction Box
Location
(junction box
may be
located in
I adjacent
I / cabinet)
(69.2 cm) Min,
27 5/16"
(69.4 cm) Ma
Recommended
cutout location
from floor 32 1/2"
(82,6 cm)
---t
22" (55.9 cm)
Min. to
Bottom of
Junction Box
---4
if the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For single
ovens, the runners and braces must
support 150 Ibs (68 Kg).
NOTE: if marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered,
These ovens are not approved for
stackable installations.
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
30" (76.2 cm)
32 1/2" (82.6 cm)
23 1/2" (59.7 cm) Min.
28 1/2" (72.4 cm) Min.
28 518" (72.7 cm) Max.
27 1/4" (69.2 cm) Min.
27 5/16" (69.4 cm) Max.
Ill not have a front frame and the
t_1sides are less than 314" (1.9 cm)
Suitable
Bracing
to Support
Runners --
-_(s4 21s/8-
.9cm)over \
Centerline
of Cabinet
-- 2"x4"
(5 cm x 10 cm
or equivalent
runners level
with bottom
of cutout
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts.
Cutout- i 2"(5.1 cm)
Observe all Min.
dimensions I_ll'='=='==='='=i_
and I
requirements.J
Cutout -
Observe all
dimensions
and
requirements.
9