Installation guide

Cabinetry
Cutoutfor 30"<76.2o_)SingleOvensonly-
Belowan Advantiumor _-rowaveOven
or BetweenanAdvantiumor crowave
OvenandaWarmingDrawer
For JTP30, JTP70, PT916, PT920, ZET938 models only.
Single 30" (76.2 cm) Oven
Below an Advantium or
Microwave Oven
Single 30" (76.2 cm) Oven
Between an Advantium or
Microwave Oven and a
Warming Drawer
__" (5.1 cm) Min,
Note: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
NOTE: The middle rail separating the two
openings may need to be larger than the 2"
(5.1 cm) m=nimum shown. Always refer to the
individual installation instructions packed with
each product for specific requirements.
Combined Advantium or Microwave
Oven and Wall Oven Installation:
When installed in combination with a
single wall oven, use separate electrical
junction boxes.
• Refer to the Advantium or microwave
oven installation instructions for electrical
requirements of that product.
These connections must be made
by a qualified electrician. All electrical
connections must meet National Electrical
Code or prevailing local codes.
Per Advantium
Microwave Oven
Requirement
Per Warming
Drawer
Req
2" (5.1 cm) Min.
2" (5.1 cm) Min.
NOTE: Additional clearances may be
required. Check to be sure the oven
supports above the Warming Drawer
do not obstruct the required interior depth
and height. The middle rail separating the
openings may need to be larger than the
2" (5.1 cm) minimum shown. Always refer to
the individual installation instructions packed
with each product for specific requirements.
WarmingDrawerCombinedwith
Advantiumor MicrowaveOvenand
SingleOven:
Install a separate 120V, 60Hz, properly
grounded receptacle, See installation
instructions packed with each product
for specific requirements,
13