Built-ln Installati instructions if you have questions, ge.com 27" (68.6 cm) models JKSI0, JKP30, JKP35, JKP55, JKP70, JKP75, PK916, PK956, ZEK938, ZEK958 30" (76.2 cm) models JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 call 1.800.GE.CARES Before You Begi n • Proper Read these instructions carefully and completely. • IMPORTANT-save these instructions Wall Oven for local inspector's use. • IMPORTANT-obse_,e all governing codes and ordinances.
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS For Your Safety Electrical • Be sure your oven is installed properly by a qualified installer or service technician. Requirements • Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit, stand or hang on the oven door.
Installation Instructions Pre-lnstallation Checklist Door removal is not a requirement for installation of the product, but is an added convenience. To remove the door: ALL INSTALLATION INFORMATION ON THE FOLLOWING PAGES IS TO BE USED FOR SINGLEAND DOUBLE OVEN INSTALLATION! Open the oven door as far as it will go. i Remove packaging materials. Check behind hinges and under false bottom.
Installation instructions Cutou for 27"(68.6 Ovens only For JKS10, JKP30, JKP70, PK916, ZEK938 models Cabinet 5" (12.7 cm) Max. from the left or right Cabinet_ !_L Junction Location i 27" (68.6 Cutout 25" over Width (83.5 only. Width 27" (68.6 cm) Recommended Cutout Location from Floor Box i ,:, "!-' 32 1/2" (82.6 cm) Cutout Depth 23 112" (59.7 cm) Min. Cutout Width 25" (63.5 cm) Min. T cm) Min. 25 1/4" (64.1 Max. Allow 1" (2.
Installation instructions Cutoutfor 27"(68.6 DoubleBuilt-in Ovensonly For JKP35, JKP55, JKP75, PK956, ZEK958 models only. 6" (12.7 cm) Max. from the left or Cabinet Cabinet Width Recommended Cutout Location right i (68.6 cm) Cutout Junction Box from Floor (64.icm)M_TlX, (33.7 cm) Cutout Depth 23 5/8" (60 cm) Min. Cutout Width 25" (63.5 cm) Min. 25 i/4" (64.i cm) Max. edges of cutout (111.8 cm) iCut°ut Cutout Height Min, Above o B# Allow i (2.
Installation Instructions IAICutout for 27" (68.6cm)Single Built-In Ovens only Under Counter For JKS10, JKP30, JKP70, PK916, ZEK938 models only. Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size, See label on top of oven for approved cooktop models. ,\ 240V / 208V Junction Box Location \ 25" (63.5 cm) \ \ 5" (12.7 cm) Max.
Cabinetry Cutout for 27" (68.6c_)Single or Double uilt-ln Ovens only-Over arming Drawer a For JKSI0, JKP30, JKP35, JKP55, JKP70, JKP75, PK916, PK956, ZEK938, ZEK958 models only. Double 27" (68.6 cm) Oven Over a Warming Drawer Single 27" (68.6 cm) Oven Over a Warming Drawer Anti-Tip Block Against Rear •Wall Per Warming Drawer Requirement Anti-Tip B!ock Against Rear Wall Per Warming Drawer Requirement 2" (S.1 cm) Min. 2" (5.1 cm) Min.
Cabinetry Cutoutfor 27"(68.6 _)Single OvensonlyBelowan Advantiumor ;rowaveOven or Betweenan Advantiumor crowave Ovenand a rmingDrawer For JKSI0, JKP30, JKP70, PK916, ZEK938 models Single 27" (68.6 cm) Oven Below an Advantium or Microwave Oven only. Single 27" (68.
Installation Instructions Cutout for 30"(76.2 Ovens only Built-In cm)Single For JTP30, JTP70, PT916, PT920, ZET938 models only. Cutout Width 28 1/2" (72.4 cm), 7 3/4" (19.7 cm) Max. Junction Box -fLocation 28 5/8" (72.7 cm). "====_: Max. may be located in adjacent Allow 11/16" (1.75 cm) for overlap of oven over side edges of cutout -<- Min. / __ cabinet) (junction box Cabinet Width 30" (76.2 cm) Recommended Cutout Location from Floor 32 1/2" (82.6 cm) Cutout Depth 23 1/2" (59.7 cm) Min.
Installation Instructions IAICutoutfor30' 6.2cm)Double Built-InOvensonly For JTP35, JTP55, JTP75, PT956, PT960, ZET958 models only. Cutout Width 28 1/2" (72.4 cm) _Min, --)28 5/8" (72.7 cm) ==: Max. 7 3/4" (19.7 cm Junction Box ) Location (junction box may be located in adjacent cabinet) I / Allow 11/16" (1.76 cm) for overlap of oven over side edges of cutout Allow a minimum of 21" (53.3 cm) for clearance to adjacent corners, drawers, walls, etc, when door is open -1 I Must 47" (119.4 cm) Min.
Installation instructions Built-inOvens Cutout for 30"( 6.2 cm) ng only nder Counter For JTP30, JTP70, PT916, PT920, ZET938 models Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size. See label on top of oven for approved cooktop models. only. 240V / 208V Junction Box Location (junction box may be in adjacent cabinet) 7 314" (19.7 cm) Max.
Cabinetry Cutout for 30"(76.2cm) Single or Double Built-In Ovens only- Over a Warming Drawer For JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 models only. Double 30" (76.2 cm) Oven Over a Warming Drawer Single 30" (76.2 cm) Oven Over a Warming Drawer Block Against Rear Wall Per Warming Drawer Requirement Anti-Tip Block Against Rear Wall Per Warming Drawer Requirement 2" (5.1 cm) Min. NOTE: install the 2" (5.1 cm) Min.
Cabinetry [_ Cutoutfor 30"(76.2 c_)Single Ovens only Below an Advantium or :rowave Oven or Between an Advantium or crowave Ovenand a rmingDrawer For JTP30, JTP70, PT916, PT920, ZET938 Single 30" (76.2 cm) Oven Below an Advantium or Microwave Oven models only. Single 30" (76.2 cm) Oven Between an Advantium or Microwave Oven and a Warming Drawer P_W v Per Advantium Microwave Oven Requirement 2" (5.1 cm) Min. " (5.1 cm) Min.
Installation Instructions Electrical Connections ATTENTION Turn off the circuit breaker or remove fuses to the oven branch circuit. INSTALLER All electric wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products. With the oven supported on a table or platform in front of the cabinet opening, connect the flexible conduit to the electrical junction box as shown below.
Installation Instructions New Construction and Four-Conductor Branch Circuit Connection • When installing in new construction, • When installing in a mobile home, or • When installing in a recreational Three-Conductor Branch Circuit Connection When connecting to a three-conductor circuit, if local codes permit: or vehicle, branch a. Connect the bare oven ground conductor with the crimped neutral (white) lead to the branch circuit neutral (white or gray in color), using a wire nut.
Installation Instructions lcl Securing the Oven in the Opening I_ Sliding the Oven Into the Drilling the Pilot Holes and Mounting the Oven Opening a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid into place. This will keep the conduit from falling behind the oven. NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening as it will go and centered.
Installation Instructions Installing the Metal Bottom Trim Preparing for the Bottom Trim Installation a. With oven installed, take the bottom trim and center it on the bottom front edge of the cabinet opening. b. Using the trim as a template, mark the center of each slot (two total) where the mounting holes will be drilled. c. Remove the trim. d. Drill pilot holes into the center of each template mark. a. For 27" (68.
Installation Instructions ID-IReplacing the Oven Door NOTE: The oven door is heavy. You may need help lifting the door high enough to slide it into the hinge slots. Do not lift the door by the handle. I-_ Open the oven door as far as it will open. r-_ Push the hinge locks up against the front frame of the oven cavity, to the locked position. i Hinge in Locked Position Lift the oven door by placing one hand on each side. The door is heavy, so you may need help. Do not lift the door by the handle.
Installation Instructions Pre-Test Checklist I_ emove all protective and any stickers. I_ heck to be sure that all wiring is secure and not pinched or in contact with moving parts. Check that the bottom trim is installed properly (see page 17). film, if present, Check to be sure the mounting screws are installed and flush with the side trim (see page 16). Operation Checklist Remove all items from the inside of the oven. I&JlV Check that conduit is securely connected to the junction box.
Notes 20
