Installation guide

Drilling the Pilot Holes and
Mounting the Oven
sure the oven is pushed as far back into
the opening as it will go and centered.
a. Drill through the mounting holes of the side
trim, for the #8 screws provided.
............. zm_
Mounting Hole
S Locutions
(two provided)
I_aW ""'"O:,ount,o0,c ew,
must be used. Failure to do so could [[[
result in the oven falling out of the [[I
cabinet causing serious injury. 111
b. Secure the oven to cabinet with screws
provided.
NOTE: If the cabinet is particle board, gou must
use #8 x 3/4" particle board screws. These meg
be purchased at ang hardware store.
r&]
Installing the Lower Oven
Rack Supports and Oven
Racks
Oven Rack Supports
Place the rack support with slotted holes over
the rear bolts and round holes over the front
bolts. Using a nut driver 7/16" (11 mm), lightly
secure with four nuts but do not overtighten or
the enamel could be chipped. Repeat for the
second rack support.
Slotted Round
holes over holes over
rear bolts front bolts
Oven Rocks:
Place the rear rack lock bar over and onto the
rack supports, slide the rack all the way in until
the rear rack lock bar drops below the rack
supports. Pull rack forward and make sure the
rear rack lock bar is engaged under the rack
support.
11