Installation guide

Securing the Oven in the Opening
[_ Sliding the Oven Into the
Opening
o. Loopldo nettle} a 72" (183 cm) string around
the conduit before the oven is slid into place.
This will keep the conduit from falling behind
the oven.
"_: H: U
"_ _ f_ Q Q f' p m
b_
C_
d_
Lift oven into cabinet cutout using the oven
opening as a grip. Do not lift the door by the
handleJ Carefullg push against oven front
frame. Do not push against outside edges.
As gou slide the oven back, pull the string
so that the conduit will lie in a natural loop,
behind the oven.
When gou are sure the conduit is out of the
wag, slide the oven 3/4 wag back into the
opening. Remove the string bg pulling on one
end of the loop.
[_ Installing the Metal
Bottom Trim
a. Place the bottom metal trim under air
divider, with side flush against side trim.
Do this with the unit 4" out of the cabinet.
b. Using two trim screws provided, secure
the bottom trim to the bottom duct asm.
"_ Bottom Trim._
Trim Screw
Install bottom trim
with unit 4"
out of cabinet
IMPORTANT: If this unit is ever removed
from the cabinet or the oven is ever
pulled out for service, pull unit out 4" and
remove the bottom trim. This will prevent
damage to the trim.
10