Installation Guide

ManualsBrandsGE ManualsIndoor FixturesGE PowerGrid

Product Codes

75612

Installation Guide

Lighting

Tetra

Dimming Module

LED ARCHITECTURAL SERIES

LED System Features

• Certied to UL 2108

• IP54: Dry or damp location rated

• Compatible with any 12 or 24 Volt Tetra LED System

• Compatible with most 0-10V Dimming Controllers

For use in the following applications:

• Creates custom lighting levels

Save These Instructions

This product is intended solely for the use of non-

residential architecture lighting and is not intended

for use in any other applications.

BEFORE YOU BEGIN

Read these instructions completely and carefully

Prepare Electrical Wiring

Electrical Requirements

• Do not use in wet locations.

• The grounding and bonding of the LED Driver shall be

done in accordance with National Electric Code (NEC)

Article 600.

• Follow all National Electric Codes (NEC) and local codes.

imagination at work

WARNING/AVERTISSEMENT

Risk of electrical shock. Disconnect power before servicing or

installing product.

Risque de choc électrique. Couper l’alimentation avant le

dépannage ou avant l’installation du produit.

Summary of content (4 pages)

PAGE 1
GE Lighting Installation Guide Tetra® Dimming Module LED ARCHITECTURAL SERIES Product Codes 75612 LED System Features • Certified to UL 2108 • IP54: Dry or damp location rated • Compatible with any 12 or 24 Volt Tetra LED System • Compatible with most 0-10V Dimming Controllers For use in the following applications: BEFORE YOU BEGIN Read these instructions completely and carefully WARNING/AVERTISSEMENT Risk of electrical shock. Disconnect power before servicing or installing product.
PAGE 2
Attach Tetra Dimming Module to Tetra LED Lighting Systems Option A Tetra LED system - two wire systems White (-) White (-) Red (+) Red (+) Connect the (+) red output wire of the Tetra Dimming Module to the red (+) input wire of the Tetra LED system. Connect the (-) white output wire of the Tetra Dimming Module to the (-) white input wire of the Tetra LED system. Refer to the Tetra LED system for specific connection and loading information.
PAGE 3
Attach Tetra Dimming Module to 12V or 24V Tetra LED Drivers CAUTION Risk of damage. This is a low voltage device. Only 12/24VDC LED Driver should be attached to the black/red input leads. Damage to the dimming module may result if connected directly to 120/240VAC. Black (-) Black (-) To Dimming Controller Connect the red (+) input wire of the dimming module to the red (+) output wire of the LED driver. Connect the black (-) input wire of the dimming module to the black (-) output wire of the LED driver.
PAGE 4
Technical Requirements 1. LED light output is controlled by DC voltage applied to the control leads (0-10V DIM purple and gray) on the dimming module. 2. The dimming control device must accept, or sink, the LED Driver’s DC current flow (maximum of 500 microamps per dimming module). 3. The LED Driver control leads are isolated from the power lines and are rated Class II. As many dimming module units as desired may be connected in parallel in a bus configuration.