Installation guide

Installation Instructions
Cutout for 27"(68.6cm)Single Built-In
Ovens only
For JKS10, JKP30, JKP70, PK916, ZEK938 models only.
Allow 1" (2.5 cm)
for overlap of
oven over side
edges of cutout
2"x4"
(5crux lOcm)
or
runners level
with bottom
of cutout
5" (12.7 cm)
Max. from the
left or right
Cabinet _ side
--Width _
" l
Cutout Width
25" (63.5 cm)
Min. _"
25 114" (64.1
Max.
Junction Box
Location
Cutout
Height 22" (55.9 cm)
27 5/8" Min. above
(70.2 cm) Min. base rail
28 1/8"
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
27" (68.6 cm)
32 1/2" (82.6 cm)
23 1/2"
(59.7 cm) Min.
25" (63.5 cm) Min.
25 1/4" (64.1 cm) Max.
27 5/8" (70.2 cm) Min.
28 1/8" (71.4 cm) Max.
20" (50.8 cm)
_joJ-" j--
- 7-
-.. __. ___ -.. .......Allow
Allow a minimum 1 3/8" (3.5 cm)
minimum for
of 20" (50.8 cm) for
clearance to adjacent overlap of
corners, drawers, walls, oven top and
bottom
etc. when door is open of cutou_"-_
Recommended
cutout location
from floor 32 1/2"
(82.6 cm)
Alternate Junction
Box Location -
access from
adjacent cabinet
may be required
NOTE: If the cabinet does not
have a front frame and the sides
are less than 3/4" (1.9 cm) thick,
shim both sides equally to
establish the cutout width.
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For
single ovens, the runners and braces
must support 150 Ibs (68 Kg).
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
2"x4"(5cmx 10cm) or
equivalent runners level
with bottom of cutout
T
24"
(61 cm)
1
f
I_- 18" (45.7 cm)
--i
27" (68.6 cm) "_
These ovens are not approved for
stackable installations.
4