Installation guide

ManualsBrandsGE ManualsCooktopOfficial GE cooktop

I stollotio

I structio s

36" Electric Cooktop

CP6500 JP655, JP656, PP962, PP972, PP975, PP980,

ZEU36K

F?] "If you have questions, call 800.GE.CARES or visit our website at GEAppliunces.com

BEFORE YOU BEGIN

Reod these instructions completely

and carefully.

.IMPORTANT - Savetheseinstructions

for local inspector's use.

. IMPORTANT - Observeollgoverning

codes and ordinances.

, Note to Instoller- Be sure to leave these

instructions with the Consumer.

, Note to Consumer - Keep these instructions for

future reference.

, Product failure due to improper installation is not

covered under the Warranty.

AWARNING - Thisappliancemust be

properlygrounded.

oATTENTION INSTALLER - ALL

COOKTOPS MUST BE HARD WIRED IDIRECT

WIRED} iNTO AN APPROVED JUNCTION BOX. A

"PLUG AND RECEPTACLE" iSNOT PERMITTED

ON THESE PRODUCTS.

, Proper instollotion is the responsibility

of the instoller ond product foilure due to

improper instollotion is NOT covered under

warranty.

MATERIALS YOU WILL NEED

Junction Box Wire Nuts

TOOLS YOU WILL NEED

Pencil

Phillips Head

Screwdriver

Ruler or Straightedge

SaberSaw

1/8"DrillBit& Electricor

Hand Drill

Safety Glasses

PARTS INCLUDED

4 Screws

(WB1X!!37)

Foam Tape

2 Hold Down

Brackets

31-I0636-5 (07-13GE) 1

Summary of content (16 pages)

PAGE 1
I stollotio 36" Electric Cooktop I structio s CP6500 JP655, JP656, PP962, PP972, PP975, PP980, ZEU36K F?] "If you have questions, call 800.GE.CARES or visit our website at GEAppliunces.com BEFORE YOU BEGIN Reod these instructions and carefully. MATERIALS YOU WILL NEED completely - Save these instructions .IMPORTANT for local inspector's use. Junction Box . IMPORTANT - Observe ollgoverning Wire Nuts codes and ordinances. , Note to InstollerBe sure to leave these instructions with the Consumer.
PAGE 2
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS w FOR YOUR SAFETY ELECTRICAL REQUIREMENTS . For Personal Safety, remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or death. This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or a time delay fuse as noted on name plate. .
PAGE 3
Installation PRE-INSTALLATION Instructions CHECKLIST D A WARN ING - Theelectrical power to Remove Installation Instructions from literature pack and read them carefully before yo u begi n ......... s_ms.r:;, ...... the cooktop supply line must be shut off while connections ere being made. Failure to do so could result in serious injury or death. r_ r_ Be sure to place all literature, Owner's Manual, Installations, etc. in a safe place for future reference.
PAGE 4
Installation PREPARING THE OPENING F_ CUTOUT DIMENSIONS COUNTERTOP Instructions (CONT) E_ OF THE For Americans with Disabilities Act (ADA) Forward Approach Installation Only: To insure accuracy, it is best to make a template when cutting the opening in the counter. For models with no drop box, allow 5" minimum th of cut cutout and the wall _.-__ _ depth between the countertop and an enclosure.
PAGE 5
Installation Instructions iNSTALLiNG THE COOKTOP INSTALLING THE JUNCTION BOX Install an approved junction box where it will be easily reached through the front of the cabinet where the cooktop will be located. The cooktop conduit is 4 feet long. [_] ATTACH FOAM TAPE Apply the foam tape around the outer edge of the glass. Do not overlap the foam tape. Bottom of Cooktop - - -_ Foam Tape -. Install junction box so that it can be reached through the front of the cabinet. '-. ......................
PAGE 6
Installation Instructions iNSTALLiNG THE COOKTOP (CONT.} [_] INSERT COOKTOP INTO CUTOUT Insert the cooktop centered into the cutout opening. Moke sure the front edge of the countertop is porollel to the cooktop. Moke finol check thot oil required cleoronces ore met. ATTACH HOLD DOWN TO CABINET BRACKETS Open the cobinet door ond screw the Hold Down Brockets to the cobinet sides with the screws provided.
PAGE 7
Installation INSTALLATION--ELECTRICAL D Instructions CONNECTIONS When making the wire connections, use the entire length of conduit provided. The conduit must not be shortened. r_ once the connections are made, secure wires together using wire nuts. Red With the cooktop in place, open the front of the cabinet door. El Relief Clamp Insert the wires from the conduit through openinq of the junction box.
PAGE 8
Installation Instructions CHECKLISTS [i] [] D PRE-TEST CHECKLIST Remove all protective stickers. []_] OPERATION film, if present, and any Remove all items from the top of the cooktop surface. Check to be sure that all wiring is secure and not pinched or in contact with moving parts. [] Check B1 Check level of appliance. that the cooktop is properly grounded. CHECKLIST Turn on the power to the cooktop. (Refer to your Owner's Manual.) Verify that all surface burners operate properly.
PAGE 9
Instruccio Estufa el ctrica deinstalaci6n CP650, JP655, ZEU36K r_ ,,si tiene alguna pregunta, Ilame al 800.GE.CARES PP962, o visite nuestro PP972, PP975, PP980, sitio Web en GEAppliances.com NECESlTARA LOS SlGUIENTES MATERIALES ANTES DE COMENZAR Lea estas instrucciones y con cuidado. JP656, e 36" por completo .IMPORTANTE - Conserve estas instrucciones poro el uso del inspector local. . IMPORTANTE -cumplocontodos los Caja de empalmes c6digos y reglus uplicubles.
PAGE 10
Instrucciones de instalaci6n INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD REQUISlTOS ELECTRICOS . Para su seguridad personal, retire los fusibles de su hogar o bien abra el cortacircuitos antes de comenzar con la instalaci6n. El no hacerlo puede resultar en lesiones serias o incluso la muerte. Este aparato debe contar con el voltaje y frecuencia adecuados, y deber6 conectarse a un circuito derivado individual debidamente .
PAGE 11
instrucciones de instalaci6n J J LISTA DE VERIFICACION PREVIA A LA INSTALACION A ADVERTENCIA - Lacorriente el_ctrica a la tuberia de abastecimiento cortarse durante la realizaci6n no hacerlo rnuerte. B] B] puede resultar rc] de la estufa debe de conexiones. El en una lesi6n seria o la [] Retire los materiales de empaque y el material impreso de la estufa antes de comenzar la instalaci6n.
PAGE 12
Instrucciones de instalaci6n J PREPARACION DE LA ABERTURA (CONT) []_] INSTALACI6N POR DELANTE UNICAMENTE DE ACUERDO CON LA LEV DE ESTADOUNIDENSES CON INCAPACIDADES (ADA) DIMENSIONES DEL AREA CORTADA EN EL MOSTRADOR Para garantizar la precisi6n, es mejor crear una plantiiia ai momento de cortar ia abertura en el mostrador.
PAGE 13
Instrucciones de instalaci6n J INSTALACION rT] DE LA ESTUFA INSTALACION DE LA CAJA DE EMPALMES Instale una caja de empalmes aprobada en un lugar de f6cil acceso a trav6s del frente del gabinete en donde pueda colocarse la estufa. El conducto de la estufa tiene 4 pies de Iongitud. APLIQUE LA CINTA DE ESPUMA Aplique la cinta de espuma alrededor del borde externo del vidrio. No aplique un exceso de cinta de espuma. Parte inferior de la estufa j - -. Cinta de espuma ' •///lj/lj j j/ o //_ .
PAGE 14
Instrucciones de instalaci6n J INSTALACION [_] DE LA ESTUFA (CONT.} INSERTE LA ESTUFA EN EL AREA CORTADA Inserte la estufa centrada en el 6rea cortada. Aseg@ese de que el borde frontal del mostrador est6 paralelo con respecto a la estufa. Aseg0rese de verificar al final que todos los espacios especificados hayan sido respetados. [_ SUJETE LAS ABRAZADERAS AL GABINETE DE MONTAJE Abra la puerta del gabinete y atornille las abrazaderas de montaje a los lados del gabinete con los tornillos incluidos.
PAGE 15
Instrucciones de instalaci6n J J INSTALACION--CON EXION ES ELECTRICAS r_ cuando realice las conexiones de cables, utilice toda la extensi6n del conducto incluido. El conducto no debe reducirse. r_ una vez que se hayan realizado las conexiones, fije los cables con las tuercas para cables. R#o Con la estufa colocada en su lugar, abra el frente de la puerta del gabinete. Inserte los cables del conducto a trav6s de la abertura de la caja de empalmes.
PAGE 16
Instrucciones de instalaci6n J LISTAS DE VERIFICACION LISTA DE VERIFICACI6N PREVIA Retire toda la pelicula protectora, si la hay, y las calcomanias. j_] [] Verifique que todos los cables est6n fijos y que no est6n torcidos o en contacto con partes m6viles. Retire todos los objetos que se encuentren sobre la superficie de la estufa. Encienda (Consulte que todas funcionen Verifique el nivel del aparato. Verifique que la estufa est6 descargada a tierra correctamente.