Manual

Performance Data Sheet.
SmartWater Filtration system GXIS50F
Using Filter GXRLQR
[] This Sgstem has been tested according to NSF/ANSI 42 and 55 for the
reduction of the substances listed below. The concentration of the indicated
substances in water entering the sgstem was reduced to a concentration
less than or equalto the permissiblelimit for water leavingthe sgstem,as
specified in NSF/ANSI 42 and 55.
[] Actual performancemag varg with local water conditions.
[] Do not use with water that is microbiologicallgunsafe or with water of
unknown qualitg without adequatedisinfection before or after the sgstem.
Sgstemscertified for cgst reduction mag be used on disinfected waters that
mag contain filterable cgsts.
Hoja de datos de funcionamiento.
Cartucho GXRLQRde sistema de filtraci6n
GESmartWater GXISSOF
[] Estesistemase hasometido a las pruebasNSF/ANSI/42y 53a fin dereducir
lassustanciaspresentadasa continuaci6n.Seredujola concentraci6n
delas sustanciasindicadasenel aguaque ingresanen el sistemaa una
concentraci6nmenoro igualal limite permitidopara elagua que saledel
sistema,coma seespecificaenNSF/ANSI42 y 53.
[] Eldesempeflorealpuedevariarde acuerdoalas condicioneslocales
del agua.
[] No use con agua que sea microbial6gicamente insegura o de calidad
desconocida sin una desinfecci6n adecuada del sistema antes o despu@s.
Lossistemas certificados para la reducci6n de esporas pueden set usados
en agua desinfectada que podria contener esporas filtrables.
Parameter
Par6metro
Chlorine/Clara
T&O
Particulate**/
Particulas
USEPA
MCL
USEPA
MCL
Influent
Challenge Concentration
Calidad del
influ_lente concentraci6n
2.0 mg/L ± 10%o
> 10000 particles/
partkulas/mL
Standard No. 42: Aesthetic Effects t Est6ndar No. 42: Efectos est6ticos
Influent Effluent
Average
Promedio
influ_tente
1.88 mg/L
5700000 #/mL
Standard No. 53: Health Effects
USEPA Influent
Parameter MCL Challenge Concentration
USEPA Calidad del
Par6metro MCL influ_lente concentraci6n
Turbidit_/Turbidez 1 NTU*** 11 ± 1 NTU***
CLlsts/Quistes 99.95% red. Min. 50000L
7 8
Asbestos/Amianto 99% red. 10 and/U 10 fibers/fibras/L;
fibers/fibras >10 pm
Ionq/de larqo
Lead/Homo, 0.015 mg/L 0.15 mg/L ± 10%
pH 6.5
Lead/Homo, 0.015 mg/L 0.15 mg/L ± 10%
pH 8.5
Hercurg/Hercurio, 0.002 mg/L 0.006 mg/L ± 10%
pH 6.5
Hercurg/Hercurio, 0.002 mg/L 0.006 mg/L ± 10%
pH 8.5
Lindane 0.0002 mg/L 0.002 mq/L ± 10%
Atrazine 0.003 mg/L 0.009 mg/L ± 10%
Influent
Average
Promedio
influ_]ente
11.18 NTU
220000 #/L
155 MF/L
0.153 mg/L
0.150 mg/L
0.006 mg/L
0.006 mg/L
0.002 mg/L
0.00875 mg/L
Average Maximum
Effluwente
Promedio M6ximo
<0.05 mg/L 0.06 mg/L
30583 #/mL 69000 #/mL
% Reduction
Average Minimum
% de reducci6n
Promedio Minima
>97.26% 96.84%
99.52% 98.94%
' Est6ndar No. 53: Efectos relativos a la salud
% Reduction
Maximum
Effluent
Average
Effluwente
Promedio M6ximo
0.315 NTU 0.049 NTU
0 0
<1 <1
<0.001 <0.001
<0.001 <0.001
0.00026 0.0005
0.0008 0.0015
0.000025 0.00007
<0.002 <0.002
Average Minimum
% de reducci6n
Promedio Minima
97.12% 95.15%
>99.99% >99.99%
>99.99% >99.99%
>99.35% >99.35%
>99.35% >99.35%
98.72% 90.91%
98.72% 75.93%
98.72% 96.50%
76.99% 75.31%
Min. Required
Reduction
Reducci6n
minima necesada
>50%
>85%
Min. Required
Reduction
Reducci6n
minima necesaria
0.5 NTU
>99.95%
99%
0.010 mg/L
0.010 mg/L
0.002 mg/L
0.002 mg/L
0.0002 mg/L
0.003 mg/L
*Tested using a flow rate of 0.78 gpm {2.95 Vmin);pressure of 60 psig; pH of 7.5± 0.5;temp. of 68° ± 5°F(20° ± 3°0 / Probado utilizando una tasa de flujo de 0,78 gpm {2,95 I/min); presi6n de 60 psig; pH
de 7,5± 0,5; temp. de 68° ± 5° F (20° ± 3° C)
**Measurement in particles/mL Particles used were 0.5-1 microns. / Medid6n en partkulas/mL Las particulas usadas eran de 0,5-1 micr6n.
***NTU-Nephelometric Turbiditg Units / NTU-unidades de turbidez nefelom@rica
O_erating Specifications / Especificaciones de operaci6n
Capacitg: certified for up to 750 gallons {2,838 I);up to six months / Capacidad: certificado para hasta 750 galones (2838 I);hasta seis meses
Pressure requirement: 35-120 psi (2.8-8.2 bar) / Requerimientos de presi6n: 35-120 psi (2,8-8,2 bar)
Temperature: 33-100°F (0.6-38°0 / Temperatura: 33°-100 ° F{0,60-38° C)
Flow rate: 0.78 gpm {2.95I/min) / Tasa de flujo: 0,78 gpm {2,95 I/min)
Replacement Filter Canister/Estimated Replacement Costs
GXRLQR-Replacementfilter canister$50-5 S
Forreplacement parts,call toll-free 800.626.2002.
Repuestodel cartucho del filtro/Costos estimados de reposici6n
GXRLQR-Repuestodel cartuchodelfiltro $30-35
Pararepuestos,Ilamegratis a1800.626.2002(EEUU.).
4