Specification

ManualsBrandsGE ManualsAppliances30 in. 5-Burners Slide-In Gas Range in Stainless Steel with Crisp Mode

GGS500SV

500 Series 30" Slide-in Gas Range

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

For answers to your Monogram, GE Café

™

, GE Profile

™

or GE Appliances

product questions, visit our website at geappliances.com or call

GE Answer Center

Service, 800.626.2000.

Specification Revised 4/23

All GE ranges are equipped

with an Anti-Tip device. The

installation of this device is an

important, required step in the

installation of the range.

ADA

COMPLIANT

Provide adequate clearances between the range and

adjacent combustible surfaces. These dimensions must

be met for safe use of your range.

Allow 30" (76.2 cm) minimum clearance between

burners and bottom of unprotected wood or metal

cabinet, or allow a 24" (61 cm) minimum when bottom

of wood or metal cabinet is protected by no less than

1/4" (6.4 mm) thick flame-retardant millboard covered

with no less than No. 28 MSG sheet metal (.015" [.38

mm] thick), .015" (.38 mm) thick stainless steel, .025"

(0.64 mm) aluminum or .020" (0.5 mm) copper.

Installation of a listed microwave oven or cooking

appliance over the cooktop shall conform to the

installation instructions packed with that appliance.

For island installation, maintain 2-1/2" minimum from

cutout to back edge of countertop and 3" minimum

from cutout to side edges of countertop.

NOTE: Door handle protrudes 3" from door face.

Cabinets and drawers on adjacent 45° and 90° walls

should be placed to avoid interference with the handle.

NOTE: Cabinets installed adjacent to slide-in ranges

must have an adhesion spec of at least 194° temperature

rating.

INSTALLATION INFORMATION: Before installing,

consult installation instructions packed with product for

current dimensional data.

For all installations, install the required rear trim to back

of range with 4 screws provided.

Minimum

to cabinets

below

cooktop

30"

(see note)

18"

30"

16" max

to cabinets

above

counter

6" Right side

6" Left side

Minimum

to side wall

36"

30"

3 1/4"

6 1/2"

24"

14 1/2"

12 3/8"

Side Wall

Gas

and

electrical

supply

NOTE: Minimum to bare cabinet above;

see Installation Instructions for alternate

installation configurations.

30"

36"

⁄

with handle

5/8"

NOTE: Rear

wall to front of

door glass.

⁄

w/o handle

⁄

Summary of content (2 pages)

PAGE 1
G G S50 0SV GE® 500 Series 30" Slide-in Gas Range DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) Provide adequate clearances between the range and adjacent combustible surfaces. These dimensions must be met for safe use of your range. Allow 30" (76.2 cm) minimum clearance between burners and bottom of unprotected wood or metal cabinet, or allow a 24" (61 cm) minimum when bottom of wood or metal cabinet is protected by no less than 1/4" (6.
PAGE 2
G G S50 0SV GE® 500 Series 30" Slide-in Gas Range FEATURES AND BENEFITS Slide-In Range - Easily upgrade your kitchen with this new slide-in range that is guaranteed to fit into your existing space. Crisp Mode - Crisp Mode uses the bake and broil elements to deliver air-fry like results. Perfect for your favorite air-fried foods, this mode uses a preheat to get to temperature, then delivers fantastic crispy results.