Installation Instructions

9
InstallationInstructions
LOCATING THE STOP SCREW
Carefullyslidetherangetowardsthebackofthe
opening.Whentherangeisapproximately1”from
thebackoftheopening,liftthefrontoftherange
approximately½”toclearthestopscrewlocated
inthesidesofthecabinet.Slidetherangeuntilitis
seatedintotheopening.
Lowerthefrontoftherangeontothecounter-top.
ATTACH THE LOWER TRIM
Attachthelowertrim(suppliedseparatelywiththe
range)tothebottomoftheverticalsidetrimwiththe
4screwssupplied.
7

INSTALL THE RANGE (Continued)
Side
trim
Lower
Trim
Lower
right
endof
front
frame
Remove Oven Door
1.Lifttheovendoorbyplacingone
handoneachside.thedooris
heavy,soyoumayneedhelp.Do
notliftthedoorbythehandle.
2.Withthedooratthesame
angleastheremoval
position(halfwaybetween
theclosedandbroilstop
position)seatthenotch
ofthehingearmintothe
bottomedgeofthehinge
slot.Thenotchofthehinge
armmustbefullyseated
intothebottomoftheseat.
8
REPLACING THE OVEN DOOR
Hinge Arm
Bottom
Edgeof
Slot
HingeNotch
Attach2
screws
each
side
Clear
Lower
Trim
Shoulder
Screw
NotchinBottom
ofSideTrim
Lookatbothsidesoftherangeunderthedoor.The
stopscrewsmustbelocatedinthenotchonthe
sidesoftherange,andnottouchthetopofthenotch
whentherangeisfullyseatedonthecountertop.If
thescrewsdonotmeettherequirements,movethe
screwstoapositionthatmeetstheserequirements.
(Seeillustration.)
CHECK FOR PROPER INSTALLATION OF THE STOP SCREW