Installation guide

10
MOUNT THE OVEN
WARNING
Mounting screws must be used. Failure to do so could result in the oven
falling out of the cabinet, causing serious injury.
NOTE: During oven mounting step, ensure that no damage is done to oven gasket which lines
the edge of oven cavity.
NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening
as it will go and is centered.
NOTE: If the cabinet is particle board, you must use #8 x ¾” particle board screws. These may
be purchased at any hardware store.
A. Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws
provided.
B. Secure the oven cabinet with the screws provided.
9
BOTTOM TRIM INSTALLATION
• Slide oven out by 2” and attach the bottom trim through its mounting holes in front vertical brace
using two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.
Exercise caution while sliding the unit back in after bottom trim installation. Installer needs to
ensure that the trim does not catch the edge of the cabinet and bend. Furthermore, the installer
needs to ensure that the cabinet itself is not damaged while the unit is slid back into position.
WARNING
Do not slide oven out more than noted dimension, the unit can tip over and fall
causing serious injury & damage.
The Screws Must
Be a Minimum of
¼” (6 mm) From the
Front of the Cutout.
SWO’s installation
Mounting
Hole
Locations
(hole locations
may vary)
Keep Bottom Cabinet Trim to the
Inside of the Side Cabinet Trims