Installation Guide

Lighting

Installation Guide

imagination at work

(BT Series UL version)

Lumination

LED Luminaires

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save These Instructions

Use only in the manner intended by the manufacturer. If

you have any questions, contact the manufacturer.

Tools and Components Required

• Phillips head screwdriver.

• UL approved conduit tting.

• UL approved twist-on wire connectors.

Prepare Electrical Wiring

Electrical Requirements

• LED driver must be supplied with 120-277VAC, 50/60 Hz

and connected to an individual properly grounded

branch circuit, protected by a 15 or 20 ampere circuit

breaker. Use Min. 75°C supply conductor.

Grounding Instructions

• The grounding and bonding of the overall system shall

be done in accordance with National Electric

Code (NEC) Article 600 and local codes.

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL approved wire for input/output connections.

Minimum size 18 AWG (0.75mm

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL pour les entrées/sorties de connexion.

Taille minimum 18 AWG (0.75mm

BT22 Series BT14 & BT24 Series

PAGE 1
Installation Guide GE Lighting Lumination LED Luminaires TM (BT Series UL version) BT22 Series BT14 & BT24 Series BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING/AVERTISSEMENT RISK OF ELECTRIC SHOCK • Turn power off before inspection, installation or removal. • Properly ground electrical enclosure. RISK OF FIRE • Follow all NEC and local codes. • Use only UL approved wire for input/output connections. Minimum size 18 AWG (0.75mm2).
PAGE 2
Unit Installation BT22 Series 1 Carefully unpack unit from its packaging. Properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being transferred to the luminaire. BT22 Series 2 BT14 & BT24 Series BT14 & BT24 Series Install the unit into the reserved hole in the ceiling. Note: Luminaires shall be securely fastened to the ceiling framing member by mechanical means such as bolts, screws or rivets.
PAGE 3
Electrical Connections BT22 Series 1 BT14 & BT24 Series Remove electrical enclosure cover. Remove knockout for AC line input wires. Install listed electrical fittings in the knockout holes for wire protection. BT22 Series BT14 & BT24 Series Ground wires AC line AC line Ground 2 Connect the AC line to the black (line) and white (neutral) input wires of the LED Driver using 18-14AWG twist-on wire connectors. For BT22 Series: Connect the ground wire to the green grounding wire.