Installation Guide

ManualsBrandsGE ManualsIndoor FixturesGE BT Series

Lighting

Installation Guide

imagination at work

(BT Series UL Version – EL Emergency Light Option)

Lumination

LED Luminaires

BT22 Series BT14 & BT24 Series

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS

SHOULD ALWAYS BE FOLLOWED INCLUDING THE FOLLOWING:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. Turn power off before inspection, installation or removal.

2. To reduce the risk of electric shock, disconnect both normal and emergency power suppliers

and converter connector of the emergency driver before servicing.

3. The emergency driver must be fed from the same branch circuit as the AC driver.

4. Do not attempt to service the battery. A sealed, no-maintenance battery is used that is not

 eldreplaceable.Contactthemanufacturerforinformationonservice.

5. Follow all NEC and local codes. Properly ground electrical enclosure.

6. Use only UL listed wire for input/output connections. Minimum size 18 AWG (0.75mm

7. Equipment should be mounted in locations and at heights where it will not readily be

subjected to tampering by unauthorized personnel.

8. Do not use outdoors.

9. Do not mount near gas or electric heaters.

10. Do not use this equipment for other than intended use.

11. The use of accessory equipment not recommended by the manufacturer may cause an

unsafe condition.

SAVE THESE INSTRUCTIONS

Ni-Cd Battery

The rechargeable Nickel-Cadmium battery in this product must be recycled or disposed of properly.

Summary of content (5 pages)

PAGE 1
Installation Guide GE Lighting Lumination LED Luminaires TM (BT Series UL Version – EL Emergency Light Option) BT22 Series BT14 & BT24 Series IMPORTANT SAFEGUARDS WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE FOLLOWING: READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. Turn power off before inspection, installation or removal. 2.
PAGE 2
BEFORE YOU BEGIN Read these instructions completely and carefully. Tools and Components Required Prepare Electrical Wiring Fixture Installation • Phillips head screwdriver. • UL listed conduit fitting. • UL listed twist-on wire connectors. Electrical Requirements • LED driver must be supplied with 120-277VAC 60 Hz and connected to an individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker. Use min. 75°C supply conductor.
PAGE 3
Unit Installation BT22 Series 1 Carefully unpack unit from its packaging. Properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being transferred to the luminaire. BT22 Series 2 BT14 & BT24 Series BT14 & BT24 Series Install the unit into the reserved hole in the ceiling. Note: Luminaires shall be securely fastened to the ceiling framing member by mechanical means such as bolts, screws or rivets.
PAGE 4
Indicator Test Switch Installation 1 Important: This unit must be installed with the factoryprovided remote mount Indicator test switch (ITS). Follow National Electrical Code (NEC) and local code regulations when installing the ITS. 2 Choose a suitable location in a wall or the ceiling for the ITS. Maximum remote mounting distance for the ITS is 50 feet. Install a UL listed single-gang electrical box.
PAGE 5
BT22 Series BT14 & BT24 Series To emergency driver Ground wires AC line AC line To emergency driver Ground 4 Connect the switched AC line input wire to the white/red (switched line) connection of the emergency driver. Connect the unswitched AC line input wire to the black (line) connection of the emergency driver. For an unswitched fixture, connect the unswitched AC line input wire to both the white/red and black wires of the emergency driver.