Installation Guide

Prepare Electrical Wiring

Electrical Requirements

• LED luminaire must be connected to the mains supply

according to its ratings on the product label.

Grounding Instructions

• The grounding and bonding of the overall system shall

be done in accordance to the local electric code of the

country where the luminaire is installed.

Lighting

Installation Guide

imagination at work

(For BT Series Luminaires)

Lumination

Surface Mount Kit

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save These Instructions

Use only in the manner intended by the manufacturer.

If you have any questions, contact the manufacturer.

Tools and Components Required

• Drill

• Tape measure

• Phillips head screwdriver

• Socket head screwdriver

• Fasteners capable of holding 30 lbs. (4 pcs.)

• UL approved conduit tting

• UL approved twist-on wire connectors

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL approved wire for input/output connections.

• Minimum size 18 AWG (0.75mm

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL pour les entrées/sorties de connexion.

Taille minimum 18 AWG (0.75mm

PAGE 1
Installation Guide GE Lighting Lumination Surface Mount Kit TM (For BT Series Luminaires) BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING/AVERTISSEMENT RISK OF ELECTRIC SHOCK • Turn power off before inspection, installation or removal. • Properly ground electrical enclosure. RISK OF FIRE • Follow all NEC and local codes. • Use only UL approved wire for input/output connections. • Minimum size 18 AWG (0.75mm2).
PAGE 2
Installation Attach “U” brackets Save 4 screws 1 Remove the 4 earthquake brackets that come attached on the top of each end of the luminaire (save the screws). 2 Attach the two “U” brackets to both ends of the luminaire using either the screws that were saved from the earthquake brackets or screws included in the surface mount hardware kit. 4 Insert one end of the luminaire “U” bracket in to the crossbar that has already been securely mounted to the ceiling.
PAGE 3
BT22 Series BT14 & BT24 Series AC line AC line Ground wires Ground 7 Attach UL approved conduit (rigid or flexible per installation method) to the knockout of the power supply box. Connect the AC line to the black (line) and white (neutral) input wires of the LED Driver using 18-14AWG twist-on wire connectors. Replace electrical enclsoure cover. For BT22 Series: Connect the ground wire to the green grounding wire.