45136 Wireless Alarm System Alarm Siren User’s Manual Low Batt On Armed ON/OFF LEARN Choice ALERT™ ™ Control all Sensors & accessories from one location
Table of Contents Important Safeguards Introduction Assigning a Alarm Siren to the system 4 4 5-6 Installation 6 Testing the Alarm Siren or your system 6 Erasing Alarm Siren from system 7 Low battery indicator 8 Battery warnings 8 10 FCC Warning
Before connecting or operating the Alarm Siren, please read these instructions carefully and save this manual for future reference. Congratulations The GE Choice Alert™ Wireless Alarm System is one of the most affordable and expandable wireless alarm systems available. You’ll discover the system offers many features typically found in custom installed Alarm systems. The Choice Alert system is reliable and easy-to-use.
Important safeguards Pre Cautions 1. Do not attempt to disassemble the Alarm Siren, unless described in the user’s manual. There are no user serviceable parts. 2. Handle with Care – Avoid striking or shaking. Improper use or storage could damage the Alarm Siren. Modifying or tampering the device or its internal components can cause a malfunction and void the Alarm Siren’s warranty. 3.
Parts Check List Identify all the parts before proceeding. Alarm Siren 2 - Screws Low Batt On Low Batt On Armed 2 - Plastic anchors Armed AC Apapter Low Batt On Armed The Alarm Siren will increase your system’s sound. Use in areas where the Control Center’s siren cannot be heard. Adding a Alarm Siren In order to link the Alarm Siren to the Control Center, you will need to have the Alarm Siren and Control Center near each other Step 1 - Remove cover on bottom of the Alarm Siren.
Step 2 - Press and hold the Learn button inside the Alarm Siren. The ‘ON’ indicator on the front will begin to flash and it will sound continuious beeps. Step 3 - While continuing to press the Learn button on the Alarm Siren, press and hold the Mute button on the side of the Control Center for three seconds. The Control Center will send a test signal to the Alarm Siren. When the Alarm Siren receives the test signal it will sound a long tone and the ‘ON’ indicator will stop flashing.
wood, or the screws and anchors included for drywall mounting, as shown in diagram (2). 1. Wood (screws only) Drywall (screws & anchors) - 2. Wood (screws only) Drywall (screws & anchors) - Erasing the Alarm Siren from the system Step 1 - Remove the AC Adapter and battery from the Alarm Siren. Step 2 - With the AC Adapter and battery removed, press and hold the Learn button. Step 3 - While pressing the Learn button, re-install AC Adapter. The LEDs will flash rapidly and the Alarm Siren will sound beeps.
Low Battery Indicator The Alarm Siren offers battery back-up using a “9V” battery. Remove screws marked with arrows on back and attach battery to tab according to polarity markings. When the battery voltage reaches a low level, the “Low battery” LED indicator on the front will begin to flash until battery is replaced. If the battery is not installed the “Low battery” LED indicator will remain on.
FCC Warning Any unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal laws. The Choice Alert system complies with part 15 of the FCC rules. Operation is subject to the following conditions: 1) The Choice Alert system may not cause harmful interference. 2) The Choice Alert system may accept any interference received including interference that may cause undesired operation.
WARNING Limitations of Alarm Products This product should be tested periodically to make sure it is working properly. The product, if used properly, may reduce the risk of burglary, robbery, or other adverse events. However, JASCO is not an insurer, this product is neither insurance nor a guarantee that such an event will be prevented, and users should protect themselves with proper insurance.
is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114. This Jasco product comes with a 1 year limited warranty. Visit www.jascoproducts.com for details.
