Full Product Manual

Surge Protector
Instructions
1. Set the power switch to the “OFF” position. Plug the surge protector
into a standard grounded wall receptacle by fully inserting the
plug and ensure that there are no exposed conductors.
2. Make sure electronic equipment is turned off before plugging into
the surge protector outlets. Do not use extension cords to connect
equipment to the surge protector.
3. Set the power switch to the “ON” position. The surge protector will
now be providing power and surge protection.
4. Connected equipment can now be turned on.
NOTE: Check indicator light(s) periodically. A glowing red indicator light
shows that surge protection is being provided. In the event that the protection
capacity is exceeded by a power surge or the protection components expire*,
the indicator light will not be lit and the power will be permanently shut down
to the outlets, ensuring surge protection for your electronic equipment. In this
event, the Connected Equipment Warranty is no longer valid and the surge
protector should be replaced.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free
of defects in workmanship and/or materials for the life* of the surge
protector. If such a defect should arise during the life of the surge
protector, Jasco Products Company will, at its option, either repair or
replace the surge protector without charge. This warranty does not
cover damage caused by lightning, accident, misuse or alterations to
the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan.
Even under normal circumstances and in the absence of defects,
the product’s life will expire when the surge protector’s component
capacity has been exceeded, thereby ceasing to provide protection
from surges. In this event, the Limited-Lifetime Warranty is no longer
valid and the surge protector should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return
the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco
Products Company must have an RA# included in the mailing
address to be accepted.
3. The original purchaser will be asked to send the surge protector,
a copy of the sales receipt for the product, your name, address,
phone number and a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 14021
Maximum Warranty Amount: $90,000(USD)
NOTE: This device is not a lightning arrestor, so it will not afford
protection when lightning strikes nearby power line, the house,
service entrance or antenna. The Warranty is void if a power
disturbance damages your equipment through the coax, phone
or network lines.
Jasco Products Company will pay up to the maximum warranty
amount offered for the surge protector purchased to repair or
replace up to an amount equal to the fair market value or the
original purchase price, whichever is less, of your electronics
equipment, if damaged by a transient surge (except those caused by
direct lightning), within the life* of the surge protector, while properly
and directly connected to this surge protector. JASCO PRODUCTS
COMPANY DISCLAIMS AND ASSUMES NO LIABILITY FOR ANY OTHER
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT
NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA OR
DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION
OR OTHER DAMAGES DUE TO LOSS OR DAMAGE TO EQUIPMENT,
SOFTWARE OR DATA. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights that may
vary from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer’s warranty,
extended warranties, or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be safety certified by a Nationally
Recognized Testing Laboratory.
2. The Jasco Products Company surge protector must be plugged
into properly wired and grounded outlets, no extension cords,
adapters, other ground wires, or electrical connectors may be
used, with the sole exception of other standard Jasco Products
Company 120 volt products approved for that use. The installation
must comply with all applicable electrical and safety codes set
forth pursuant to the National Electrical Code (NEC).
3. Any claim under the warranty policy must be made within 15 days
of the date of the alleged damage to the connected equipment.
For connected equipment coverage,
the following conditions must be satisfied:
A) All equipment eligible for warranty coverage must be plugged
directly into the Jasco Products Company surge protector.
Equipment connected to the protected equipment, but not
plugged directly into the surge protector will not be covered.
B) The equipment must have been damaged by a covered power
disturbance that passed through the Jasco Products Company
surge protector.
C) The Jasco Products Company surge protector must be damaged
from the power disturbance.
D) The Jasco Products Company surge protector’s protection
capacity must not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return
the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco
Products Company, Inc. must have an RA# included in the mailing
address to be accepted.
3. Jasco Products Company will determine whether the damage
to your equipment is covered by this warranty policy. If you are
covered, a claims adjuster will contact you and Jasco Products
Company will do one of the following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged
equipment.
d) Reimburse customer the initial purchase price of the damaged
equipment (customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether
the damage to the connected equipment is due to Jasco Products
Company surge protector failure by requesting that damaged
equipment be sent to Jasco Products Company for inspection.
14021 ver3
07/19/17
MADE IN CHINA
GE is a trademark of General Electric Company and is under
license by Jasco Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime warranty.
Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483
between 7:00AM—8:00PM CST.
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• FULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER
WATER-RELATED PRODUCTS
• GENERATORS AND POWER INVERTERS
• MEDICAL LIFE-SUPPORT PRODUCTS
WARNING