User's Manual

MDS 05-6399A01, Rev. D MDS Master Station 37
 Evaluate default factory configuration and lock the unit down to the required security level
When the Initial Setup wizard completes, select WizardsSD Configuration Setup, which steps you
through initial SD Radio Module configuration. Key items that should be reviewed and/or set include:
 Frequency plan
 Modem selection
 Keying mode
 Serial data interface configuration
 Encryption settings
5.6 Interface Configuration
5.6.1 Serial Interfaces
A serial cable (RJ45 cable with proper ETH to DB9 converter) may be used to connect to a COM port on
the unit to access the CLI. The default serial console settings are 115200 bps with 8N1 format. A
mini-USB-to-USB cable may also be used to connect to a Computer in case no serial port exists. If a
mini-USB connection is used, the computer must contain the appropriate device driver. A driver for serial
operation can be found on GE MDS website.
Configuring
The screen below shows console access to the COM1 serial and USB port: