User's Manual

62 MDS Mercury 16E Technical Manual MDS 05-6302A01, Rev. B
Static IP Address This is the IP address that the Mercury
transceiver uses for its management
interfaces (web, SNMP, SSH, and
telnet).
192.168.1.1
Static IP Netmask This is the Netmask used in
conjunction with the Static IP Address
255.255.255.0
Static IP Gateway This is the IP address of a Gateway
device on the network used for
inter-subnet routing.
0.0.0.0
Serial VLAN IP Address
Serial IP Address
Mode
Use static IP address or obtain one
from the network server.
Static
Static, Dynamic
Serial IP Address IPv4 serial VLAN address of this unit.
Needed if DHCP is off on serial VLAN.
192.168.2.1
Serial IP Netmask IPv4 serial VLAN subnet mask. of this
unit. Needed if DHCP is off on serial
VLAN.
255.255.255.0
Serial IP Gateway IPv4 serial VLAN. of this unit. Needed
if DHCP is off on serial VLAN.
0.0.0.0
VLAN Settings
VLAN Status The VLAN Status parameter controls
whether the VLAN capability of the
device is enabled or not. Enabling the
VLAN Status allows the configuration
of trunk and access ports along with
VLAN IDs and VLAN IP Addresses.
Disabled
VLAN Ethport Mode Defines if the Ethernet port acts as a
trunk port or as an access port. Auto
mode defines the port as a trunk port in
an AP, or an access port in a Remote
radio.
Auto
Auto, Trunk, Access
Management VLAN ID Defines the VLAN ID for traffic directed
to the radio itself, other than the
terminal server process. This VLAN ID
is used for filtering and for tagging
purposes.
2
1-4094
Serial VLAN ID Defines the serial VLAN ID assigned to
traffic directed to and from the Ethernet
port and the terminal server process in
the radio. This VLAN ID is used for
filtering and tagging purposes.
3
1-4094
LAN1 VLAN ID VLAN ID for Ethernet port 1. 4
1-4094
LAN2 VLAN ID Only for IDU BS/SU. VLAN ID for
Ethernet port 2.
4
1-4094
Default Route IF Defines the VLAN that contains the
default gateway in the radio.
MGMT
MGMT, SERIAL
Management VLAN
Mode
Applies the VLAN tag to management
frames.
Tagged
Tagged, Native
Table 17. Configuration Parameters (Continued)
Menu Location Parameter Name Description Default Value
Possible Values