GE Zoneline PTAC Installation Manual
6 49-7774
USING THE ZONELINE
Controls
About Your Heat Pump (AZ65 only)
Heat pumps can save money by removing heat from the
outside air—even when the outside temperature is below
freezing—and releasing that heat indoors.
7RJHWWKHEHVWHQHUJ\SHUIRUPDQFHIURP\RXUKHDWSXPS
don’t change the room thermostat by more than one degree
at one time. Raising the heat setting 2–3 degrees will cause
WKH=RQHOLQHWRXVHLWVHOHFWULFKHDWLQJHOHPHQWVLQRUGHUWR
reach the new temperature setting quickly.
7KHHOHFWULFKHDWLQJHOHPHQWVXVHPRUHHOHFWULFLW\WKDQKHDW
pumps and cost more to operate.
7KHUHLVDPLQXWHPLQLPXPFRPSUHVVRUUXQWLPHDWDQ\
setting to prevent short cycling.
7KHIDQVVWDUWEHIRUHWKHFRPSUHVVRUDQGVWRSDIWHUWKH
compressor cycles off.
When the outdoor temperature is lower than 25°F, heat is
provided by the electric heater instead of by the heat pump.
Temp Control
7KHWHPSFRQWUROLVXVHGWRPDLQWDLQWKHURRPWHPSHUDWXUH
7KHV\VWHPZLOOF\FOHRQDQGRIIWRNHHSWKHURRPDWWKH
same level of comfort.
Press the + pad to raise the temperature.
Press the - pad to lower the temperature.
NOTE: 7KHGLVSOD\VKRZVWKHVHWWHPSHUDWXUHQRWWKH
room temperature.
Fan, Mode and Operation Control
FAN—Sets the fan operation for HIGH or LOW.
MODE— COOL—For cooling
FAN—For fan-only operation
HEAT—For heating
OFF—7XUQVWKHXQLWRII3RZHUUHPDLQV
FRQQHFWHGWRWKH=RQHOLQH7KH)UHH]H+HDW
Sentinel features still function if active. See the
Freeze/Heat Sentinel section on page 8.
USE WALL THERMOSTAT—7KLV/('ZLOOOLJKWXSZKHQ
the unit is controlled by a wall thermostat. See page 9 for
details.
Control Lock Out
7KHFRQWUROSDQHOFDQEHORFNHGRXWWRSUHYHQWXVHUVIURP
changing the operation mode of the unit.
While the unit is in the desired operating mode, press and
KROGWKH',63/$<6+2:+,'(EXWWRQIRUVHFRQGVWR
lock the control and the desired setting. Any key press after
WKDWZLOOUHVXOWLQWKHPRGH/('DQGWHPSHUDWXUHWKDWZDV
locked to flash 5 times and then go dormant.
7RXQORFNWKHFRQWUROORFNRXWIHDWXUHSUHVVWKH',63/$<
6+2:+,'(EXWWRQIRUVHFRQGVWRXQORFNDQGUHVXPH
normal operation.
NOTE: The temperature display will flash if the control
panel is locked (see Control Lock Out section).
NOTE: When switching between modes, it may take
several minutes to completely change operation.
Quick Heat Recovery
Activates each time the thermostat is switched from OFF or
COOL mode to HEAT mode. Electric heaters are energized
until the thermostat set point is reached. On heat pump
PRGHOVWKHKHDWSXPSRSHUDWLRQZLOOUHVXPHDWWKHQH[W
call for heat.