Logic HE Range Conventional Flue Log Effect Installation User Instructions

Installation Instructions

4a.15 Pass the cables vertically through the 2 sets of eyebolts,

see Diagram 15.

4a.16 Thread the ends through the holes in the lower back of the

firebox. Pass the gas supply pipe through the hole in the

rubber seal and push the appliance into place.

4a.17 Thread the cables through the tensioner bolts and push

the threaded portions through the holes in the firebox so

that the lock nut sits against the back wall (ensure that the

nut is screwed fully up to the head of the tensioner to allow

maximum adjustment).

4a.18 Slide the locking nipples onto the cables, pull the cables taut

and tighten the locking screw. Adjust the lock nuts using a

10mm spanner until the silicone sealing strip forms a tight

seal between the fireplace opening and the firebox flange,

see Diagram 17.

4a.19 Coil up the surplus cable and locate in the back of the

firebox.

NEVER SHORTEN THE CABLES, THEY WILL BE

REQUIRED WHEN SERVICING THE APPLIANCE.

4a.20 Replace the lower cover plate.

Note: The cable adjuster may need to be tucked upward in

order to fit the lower cover plate.

4a.21 Replace the control assembly and burner, ensuring the front

of locates in front of the tabs on the base of the firebox.

Take care not to damage the liners.

4b) Screw Fixing Method

4b.1 Alternatively, this appliance can be secured back to the

fireplace opening using the screws and expansion plugs

provided.

4b.2 Remove the backing from the self-adhesive silicone sealing

strip and apply to the rear flange of the firebox ensuring that

it is positioned as close to the outer edge as is practically

possible, see Diagram 18, Arrow A.

4b.3 Place the firebox centrally in the opening and mark the

positions of the 4 fixing holes. Drill the holes and insert the 4

expansion plugs, see Diagram 19.

Slide Control

shown

4b.4 Offer the firebox into the opening and ensure that the gas

supply pipe passes through the rubber seal.

4b.5 Secure the appliance through the 4 fixing holes, see

Diagram 19.