Installation Guide

PREPARATION

Tools Required for Assembly: (Not included)

• Pencil

• Electrical drill

CAUTION: Wood blocking is preferable behind all wall surfaces. If wood blocking is not available,

the following optional fasteners are suggested: Tile/Masonry – Plastic or lead anchors

Plaster/Drywall – Toggle bolts

INSTALLATION INSTRUCTIONS

1. Uncover the wall flange under the cover flange.

Hold the grab bar up against desired position on wall,

and mark the positioning of the screw holes.

Use a measuring tape and a level for accuracy.

2. Install grab bar with 4 - #10 × 2” panhead stainless steel

screws provided for each end wall flange.

3. Slide cover flanges over wall flanges and press

firmly to complete installation.

CARE AND MAINTENANCE

To maintain the luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.

• Tape measure

• Level

• Safety glasses

Latitude

Grab Bar

General Installation Instructions

Wall Flange

Cover Flange

Wall Flange Front View

Screws