Installation Guide

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Mallet Hammer
INSTALLATION INSTRUCTIONS
1. Hold the showerbasket up against desired position on wall,
and use a pencil to mark positioning of the screw holes (Fig. 1)
Use a measuring tape and a level for accuracy.
2. Drill 5/16 in. pilot holes into the wall where the drywall anchors (E)
will be inserted.
4. Pinch drywall anchors (E) two wings together (Fig. 2),
and insert it into the hole horizontally. Tap flush with
the wall using a hammer.
5. Insert the red push pin (F) into the drywall anchors (E) until
the wings pop open. (Fig. 3) Then remove the pin.
DO NOT tap the red push pin with hammer.
5. Position the showerbasket over the anchors, place the threaded
rings (K) over the showerbasket holes, then insert the mounting screws (G)
through the threaded rings and drywall anchors, and tighten firmly with
Philips-head screwdriver. (Fig. 4)
6. Place one rubber ring (H) inside each cap (I) and secure
the caps on the mounting screws (G), one after another. (Fig. 5)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.
• Philips head screwdriver
• Tape measure
1
• Level
• Safety glasses
Fig. 1
Fig. 2
Fig. 4
Top View
GENERAL INSTALLATION INSTRUCTION
SHOWERBASKETS #1497 and #1514
C
E
G
B
A
C
K
C
a. b. c.
E
Fig. 3
a. b.
Top View
Push
E
F
Fig. 5
Top View
C
E
G
H
I
H
I