User Manual

Using an ANT+
®
Indoor Trainer
Before you can use a compatible ANT+ indoor trainer, you must pair the trainer with your watch (Pairing Your
Wireless Sensors, page 72).
You can use your watch with an indoor trainer to simulate resistance while following a course, ride, or workout.
While using an indoor trainer, GPS is turned off automatically.
1 From the watch face, press START.
2 Select Bike Indoor.
3 Press MENU.
4 Select Smart Trainer Options.
5 Select an option:
• Select Free Ride to go for a ride.
• Select Follow Course to follow a saved course (Courses, page 87).
• Select Follow Workout to follow a saved workout (Workouts, page 43).
• Select Set Power to set the target power value.
• Select Set Grade to set the simulated grade value.
• Select Set Resistance to set the resistance force applied by the trainer.
6 Press START to start the activity timer.
The trainer increases or decreases resistance based on the elevation information in the course or ride.
Climbing Sports
Recording an Indoor Climbing Activity
You can record routes during an indoor climbing activity. A route is a climbing path along an indoor rock wall.
1 From the watch face, press START.
2 Select Climb Indoor.
3 Select to record route statistics.
4 Select a grading system.
NOTE: The next time you start an indoor climbing activity, the device uses this grading system. You can hold
MENU, select the activity settings, and select Grading System to change the system.
5 Select the difficulty level for the route.
6 Press START.
7 Start your first route.
NOTE: When the route timer is running, the device automatically locks the buttons to prevent accidental
button presses. You can hold any button to unlock the watch.
8 When you finish the route, descend to the ground.
The rest timer starts automatically when you are on the ground.
NOTE: If necessary, you can press BACK to finish the route.
9 Select an option:
• To save a successful route, select Completed.
• To save an unsuccessful route, select Attempted.
• To delete the route, select Discard.
10 Enter the number of falls for the route.
11 When you are done resting, press BACK and begin your next route.
12 Repeat this process for each route until your activity is complete.
13 Press STOP.
14 Select Save.
Activities and Apps 29