User's Manual
Table Of Contents
- GMR™ 600/1200 Series Radar Installation Instructions
- Product Registration
- Contact Garmin
- Needed Tools
- Selecting a Location
- Installing the Mounting Studs and Seals
- Mounting the Radar
- Mounting the Antenna
- Installing the Voltage Converter Unit
- Installing the Power and Network Cables
- Connecting the Radar to Power Through the Voltage Converter
- Connecting the Radar to the Garmin Marine Network
- Configuring the Radar
- Installing the Field-Installable RJ-45 Network Connector (Optional)
- Unit Dimensions
- Specifications
GMR 600/1200 Series Installation Instructions 9
Installing the Network Connector
1. Keeping the wires in proper sequence, insert them into the modular plug until the ends bottom out inside the plug. Visually inspect the wires
to verify proper order before continuing. If any wires are not in the correct position, remove the plug and rearrange the wires.
2. Using an AMP Modular Plug Hand Tool and Die Set (or compatible equivalent), crimp the plug onto the wires following the recommended
procedure of the crimp-tool manufacturer.
3. After the plug is crimped, align the release tab on the plug with the corresponding notch in the cable-connection housing. Depress the tab
and push the cable through the connection housing until the plug is securely seated in the plug cavity.
Release tab
4. Screw the strain relief nut onto the housing and tighten it snugly with a 15 mm wrench. Be careful not to overtighten the nut.
5. Install the O-ring onto the housing. The cable is now ready to use.
O-Ring