Specification

Eterna-Kote
®
Silicone
+
Roof Coating is a 100% white silicone coating that provides the ultimate durability and longevity to your
roof surface. This product has the highest degree of waterproong protection and provides superior protection to all roof surfaces.
It is ideally suited for at roofs that have problems with ponding water, as well as on installations that require high degrees of water-
proong protection. The bright white nish keeps roofs cooler, which in turn can help lower cooling costs. In hot or cold climates,
this coating forms a seamless layer of waterproong protection that will stretch to prevent cracking and peeling. This premium
product has high solids and only needs one coat for a lasting nish.
www.gardner-gibson.com
Gardner-Gibson • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: [phone]
PREPARATION: All surfaces should be clean. Treat rust with proper primer. If mildew is present, surfaces should be cleaned with a
proper bleach solution (one part bleach to 2 parts water). To qualify for warranty, it is necessary to power wash (using a wide spray
tip) all surfaces before applying this roof coating. A peel test sample should be done on all roofs to verify proper long term adhesion.
APPLICATION: Surface and air temperatures must be between 45 °F and 99 °F. Apply on a clear, dry day with a max humidity level
of 70%. Use a quality 3/4” nap paint roller. Make sure the morning dew has completely dried on the roof before applying. Step 1.
Clean surface. Step 2. Repair cracks and damaged areas with S-1 Silicone
+
Sealant, and embed a layer of Universal Repair Fabric.
Allow to cure for two hours or until dry. Coating application options: If one coat application is desired, apply 1 coat at 50 sq/ft per
gallon. If applying in 2 coats, apply each coat at 1 gallon per 100 sq/ft. Finished coverage will be the same, at covering 250 sq/ft of
roof surface. DO NOT apply if heavy dew or rain is expected within 2 to 4 hours.
COVERAGE: 5 gallons will cover approximately 250 sq/ft of roof.
NOTE: Do not apply to roofs over 110 °F.
CLEAN-UP: Clean tools immediately with mineral spirits.
SHELF LIFE: Expires quickly, use before expiration date.
PRECAUTIONS: For exterior use only. Protect building inlets from product vapors or fumes. DO NOT allow product to freeze. Pro-
tective clothing, gloves and eyewear should be used during application of these products. When transporting this product, ensure
that lid is tight and pail secure and upright. DO NOT allow pail to tumble as this may cause lid to loosen and leakage to occur. Do
not transport on passenger seats or inside the passenger compartment of any vehicle. Store product in the cargo area of vehicle,
and secure over protective cloths to prevent damage due to accidental spills. For longest life, store in controlled environment,
45 °F-80 °F. DO NOT store in direct sunlight. DO NOT store at temperatures above 99 °F. Close container after use. DO NOT reuse
empty containers. Ponding water creates excessive weight on roofs and may compromise structural integrity leading to a potential
collapse hazard. Always follow the National Roong Contractors Association guidelines to remove ponding water from roof sur-
faces. Slip Warning: Use extreme caution when walking or working on silicone coated surfaces. Surface is extremely slippery and
can create a fall hazard resulting in injury or death. Use OSHA approved fall protection when on roof surfaces. Applications to TPO,
EPDM and Hypalon require a primer to qualify for warranty.
S-100
Silicone
+
Roof Coating
5570
AVAILABLE SIZES
PRODUCT CODE UNIT SIZE UNIT DIMENSIONS FILL LEVEL UNIT WEIGHT PACK UPC
5570-1-30 5 gal. 12” x 12” x 14.75” 4.75 gal / 18 L 60 lbs. 1 ea. 025056557056
• Strongest waterproof seal
• 100% Silicone rubber
• Ideal for at roofs with standing water
• Seals, reects and protects roofs
I-14
by