Instruction Manual

1.) SELECTING THE CORRECT RAIL MOUNT FOR YOUR PISTOL
The laser attaches to either a 3/8" grooved receiver or to a 5/8" “weaver-style” base. The laser is shipped with the
mounting rails for a “weaver-style” mount already installed. If you need to attach this device to a 3/8" grooved receiver,
you will need to loosen the rail screw and rotate the 5/8" weaver mounting rail so the 3/8" is visible.
2.) ATTACHING THE CORRECT MOUNT TO THE DEVICE
 BECERTAINTHATYOURPISTOLISUNLOADEDANDPOINTINGINASAFEDIRECTION.
Simply slide the appropriate rail onto your gun and tighten it into place utilizing the rail attaching screw. Note the
“weaver-style” rail utilizes a lock screw to prevent its slippage under recoil. This lock screw should be t into the
groove found on most “weaver-style” mounts.
3.) ACTIVATING THE LASER
 DONOTLOOKDIRECTLYINTOTHELASERBEAMOUTPUTAPERTUREDURINGOPERATION.PERMANENTEYE
DAMAGEMAYRESULT.
3A.) Installing The Batteries
Your new laser is powered by (3) three long-life lithium batteries.Rotate push button counter clockwise to remove.
Insert batter (+) end facing out. Install push button switch by rotating clockwise until tight.
3B.) Main On-Off Switch
With this switch, you may turn the laser on or off.
DANGER
!
WARNING
!
CAUTION
!
DANGER
!
WARNING
!
CAUTION
!