Operation Manual

If an oven light fails, it must be replaced. Heat-
resistant replacement bulbs can be obtained from
the after-sales service or specialist shops. Only use
these bulbs.
$ Warning, risk of burns! Oven lights get very hot
during use. Only replace the oven light when it is
cold.
Disconnect the appliance from the electricity before
replacing the light (switch off the household fuse or
the circuit breaker in the fuse box).
Replacing the Ceiling Light
1 Loosen the screw on the lamp cover.
Tilt down the lamp cover.
2 Pull out the bulb. Push the new bulb in firmly.
Make sure that the pins are in the correct
position.
Note: Only use a heat-resistant halogen bulb of
the same type (60 W / 230 V / G9).
Do not touch the halogen lamp with your hands.
Use a dry cloth.
3 Tilt the lamp cover up and screw it back on.
4 Switch the circuit breaker back on.
Replacing the Side Light
1 Place a tea towel in the oven to prevent
damage.
2 Pull out the shelf after undoing the knurled
nuts.
3 Push the top mounting bracket back and
remove the glass cover.
4 Pull out the bulb. Push the new bulb in firmly.
Make sure that the pins are in the correct
position.
Note: Only use a heat-resistant halogen bulb of
the same type (10 W / 12 V / G4).
Do not touch the halogen lamp with your hands.
Use a dry cloth.
5 Insert the glass cover under the bottom
mounting bracket and press it down firmly on
the top. The sloping edges must face to the
interior of the oven.
6 Remove the tea towel and switch the circuit
breaker back on.
You must replace a damaged glass cover. Suitable
glass covers may be obtained from the after-sales
service.
Replacing the Oven Lights
38