Users Manual

Operating Manual Smart Weather Sensor
34 G. Lufft Mess- und Regeltechnik GmbH, Fellbach, Germany
10 Configuration and Test
For Configuration and Test Lufft provides the proprietary software ConfigTool.NET
(successor of UMB-Config-Tool). ConfigTool.NET can also be used to update the firmware
of the Smart Weather Sensor.
The PC version of the software is available from the Lufft hom page:
https://www.lufft.com/resources/
Download the software UMB-ConfigTool.NET and install it on your computer. Use the online
help to get familiar with the program in general.
The following chapters only deal with the device specific aspects applying to the Smart
Weather Sensor.
The functions explained following may not be available for all subtypes of the Smart Weather
Sensor.
Note: Make sure to always use the latest version of ConfigTool.NET for configuration oft he
Smart Weather Sensor.
Note: During configuration and test other devices polling the UMB-Bus, e.g. modem or
LCOM must be disconnected!
Note: The connection settings of ConfigTool.NET must conform to the settings of the device.
Factory settings of the Smart Weather Sensor: Baudrate 19200Baud, data format 8N1.
Note: The previous UMB-Config-Tool is not suitable for configuration settings of the
WS100-UMB. ConfigTool.NET shall be used for configuration settings of the WS100-
UMB.
Attempts to modify the settings of the WS100-UMB by UMB-Config-Tool may render the
device inoperative.