General Instruction Book

WARNING! Light bulbs with different shapes and power ratings from the

original may seriously damage the light compartment.

2. SPOTLIGHT

To replace the lamp:

a) Make sure the appliance is disconnected from the mains power supply.

b) Remove, by levering with a screwdriver, the support ring A for the cover

glass.

c) Remove the cover glass B to access the light compartment.

d) Replace the lamp with the same type (halogen, max 20 W, 12 Volt, G4 fitting).

e) Replace the glass cover B and fasten it using the special ring A.

Lamp

Halogen light Built in dicroic spot Standard dicroic spot

3. FLUORESCENT TUBE

(Section reserved for qualified installers)

Replacing the fluorescent tube:

a) Disconnect the device from the mains;

b) Unscrew the fixing screws and remove the bottom panel;

c) Remove the fluorescent tube, by rotating through 90°, and replace it with

one of similar features (8W-13W-21W-28W according with the model);

d) Reconnect the device to the mains.

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the ap-

pliance over time. Special attention should be paid to the metal grease-trap-

ping filters and the charcoal filters. Frequent cleaning of the filters and their

supports will ensure that fats and grease do not accumulate on the range

hood, with the consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore

should be washed every month in hot water and detergent, without bend-

ing them. Wait until they are completely dry before repositioning them.

To remove and replace these filters, see the instructions in point H1. This

operation should be performed at regular intervals. The metal filters could

be cleaned in a dishwasher.